Popular New Guides Product Guides Tools Checklists My Rig

Results for "lifting"

787+ Q&A Updated Weekly Free
Splendide WDC7100XC Drum Bearing Repair & Replacement Guide
Appliances Hard Professional repair required 1,209 👍

Splendide WDC7100XC Drum Bearing Repair & Replacement Guide

Splendide combo washer-dryer started making a grinding noise during the spin cycle and now it vibrates so hard it walks across the floor. Pretty sure it's the drum bearings based on the sound. Debating between a $400 repair bill and just replacing the whole unit. …more
Monaco Diplomat Rear Air Suspension Won't Dump Fully - Troubleshooting Guide
Plumbing Medium 1-2 hours 640 👍

Monaco Diplomat Rear Air Suspension Won't Dump Fully - Troubleshooting Guide

Last week my 2006 Monaco Diplomat's rear air bags started refusing to dump all the way down when I hit the air dump before leveling. The front dumps fine, but the back stays partially inflated.

I'm still pretty new to RV maintenance and not sure where to start troubleshooting this. Should I be hearing air escaping when I activate the dump? What are the most common causes when rear air bags won't dump completely? Any guidance on what to check would be really appreciated! …more
RV Engine Stalling & Transmission Issues - Diagnosis Help
Engine Medium 2-4 hours diagnosis 402 👍

RV Engine Stalling & Transmission Issues - Diagnosis Help

Replaced multiple parts but I'm still standing in the auto parts store aisle staring at diagnostic tools with no clue which one I actually need for my RV's stalling and transmission issues. When I'm cruising and let off the gas, sometimes the RPMs drop like a rock, other times they just hang there until I slow down more. That's weird enough, but here's the real kicker - every now and then the whole engine just dies on me when I'm rolling up to a stop sign or red light. Maybe happens twice in 600 miles or so, so it's not constant but definitely not normal either.

I'm wondering if these two issues are connected somehow? Like could whatever's causing the stalling also be messing with how the transmission acts when I let off the throttle? Really hoping someone has seen this combo before because I'm in Germany and finding RV-specific help is tough.

I'm looking for any insights from folks who might know what could cause this - hoping to get to the bottom of this before it becomes a bigger problem! …more
SDI E-Clik vs Liquid Spring: Affordable F53 Chassis Suspension Upgrade Options
Engine Hard 4-6 hours installation 369 👍

SDI E-Clik vs Liquid Spring: Affordable F53 Chassis Suspension Upgrade Options

Nobody warned me that what started as minor swaying on highway trips last month would turn into white-knuckle driving every time I take my F53 chassis RV over 50mph. SDI E-Clik costs about a third of what Liquid Spring systems run, but I'm wondering what you actually get for that price difference.

Is E-Clik just electronic shock control, or does it offer more comprehensive suspension improvements? How does the ride quality compare between the two systems on F53 motorhomes? …more
Ford E350 Dually Wheel Center Hole Size Guide: Front vs Rear Differences Explained
Chassis Easy 30 minutes 368 👍

Ford E350 Dually Wheel Center Hole Size Guide: Front vs Rear Differences Explained

According to my mechanic, my Ford E350 dually has mismatched wheel fitments, center holes that don't align properly, AND different sizing between front and rear wheels all at once. I have a 2001 Ford E350 Class C motorhome with dual rear wheels, and I desperately need to get a spare tire sorted out.

I found what I thought was the perfect rim - same bolt pattern as my existing wheels - but when I got home and really looked at it, the center hole is noticeably smaller than the ones currently on my RV. I've been assuming all six rims on a dually setup would be identical, but now I'm second-guessing everything.

Could it be that Ford actually uses different center hole sizes between the front wheels and rear dually wheels on the E350? I'm really hoping someone can clarify this because I need to know if I bought the wrong type of rim or if there's something else I'm missing here. …more
RV Solar Panel Z Bracket Installation: Drill vs Adhesive Mounting Guide
Solar Batteries Medium 2-3 hours 356 👍

RV Solar Panel Z Bracket Installation: Drill vs Adhesive Mounting Guide

Ready to mount solar panels on the roof but torn between drilling through the fiberglass with Z-brackets or using VHB tape adhesive mounts. Terrified of roof leaks from drill holes but also worried the adhesive won't hold at highway speeds. Which mounting method actually holds up long term? …more

Still stuck on this repair?

Get a personalized answer from a verified RV mechanic. Describe your issue and get step-by-step help.

Chat with an RV Mechanic
27708 RV owners helped · Avg response under 5 min
RV Water Heater Not Hot Enough: Fix Lukewarm Water Issues
Appliances Medium 2-4 hours 355 👍

RV Water Heater Not Hot Enough: Fix Lukewarm Water Issues

Looked forward to our two-week cross-country trip starting tomorrow until I discovered my RV water heater that used to produce scalding hot water now barely gets lukewarm. Both the electric and gas functions appear to be working - I can hear the gas igniting and see the electric indicator light - but the water temperature just won't get hot enough for a decent shower.

I've been dealing with this for weeks now and it's driving me crazy. The water gets warm, but nowhere near the hot temperatures I used to get. Is this a common problem with RV water heaters? What are the most likely culprits when you're getting lukewarm water instead of hot? I really need to figure out what's causing this and how to fix it before my next camping trip. …more
How to Store LiFePO4 Batteries in Winter: RV Cold Weather Battery Guide
Solar Batteries Easy 1 hour preparation 331 👍

How to Store LiFePO4 Batteries in Winter: RV Cold Weather Battery Guide

Somewhere along the way, the previous owner of my newly purchased RV completely abandoned proper winter storage for these LiFePO4 batteries through multiple harsh seasons. My battery documentation shows a storage temperature range of 14° to 122°, which concerns me since Spokane winter temperatures tend to drop within 10° of zero.

The batteries are currently located under the entry steps, and I'm considering three options:
1) Leave batteries in the coach and risk potential damage like case cracking
2) Install heating pads or battery blankets
3) Remove and store batteries indoors

I'm leaning towards removing the batteries indoors, but I'd appreciate input from those with experience. Can anyone talk me out of this approach or confirm it as the best strategy? …more
How to Lift RV Slideout for Floor Repair - Safe Methods
Slideouts Hard 4-8 hours 317 👍

How to Lift RV Slideout for Floor Repair - Safe Methods

Apparently my 2000 Allegro Bus slideout only starts sagging and needing floor repair when it hits 85 degrees outside — works perfectly fine otherwise. We discovered water damage under the slideout and need to replace some plywood subflooring, but there are screws I can only access if I lift the slide somehow.

I'm worried about damaging the slideout mechanism or worse, having it fall and hurt someone. The hydraulic system seems to work fine, but I've heard you shouldn't trust it alone for this kind of work. What's the safest method to lift and support a slideout while doing floor repairs underneath? I want to make sure I'm not making a dangerous mistake here. …more
RV Battery Charging: Underhood Generators vs Engine Idling Guide
Electrical Easy N/A - planning 301 👍

RV Battery Charging: Underhood Generators vs Engine Idling Guide

Since my neighbor can boondock for weeks with perfect battery power while mine die after just a few days, what charging method am I missing? I came across this interesting information from a New York City perspective (original link: https://www.msn.com/en-us/travel/ar...S&cvid=f9f9617373f147cba291498b28b099b4&ei=17).

I've been thinking about either just idling my engine to let the alternator do its thing, or maybe installing one of those underhood generators I keep hearing about.

My buddy says idling is fine and super easy, but I'm wondering if there are any downsides I should know about - like regulations or whether it's actually efficient. Are underhood generators worth the investment, or should I be looking at completely different options? What's the real deal here? …more
Dutchstar Chassis Cracking Noise: Diagnosis & Repair Guide
Chassis Medium 45 minutes 300 👍

Dutchstar Chassis Cracking Noise: Diagnosis & Repair Guide

Hearing a loud cracking or popping noise from underneath my Dutchstar when going over bumps or turning. Sounds structural — like metal flexing or a weld breaking. Crawled under and couldn't see any obvious cracks but the noise is getting louder each trip. …more
Replace RV Residential Refrigerator Mounting Brackets
Ac Refrigeration Medium 2-3 hours 298 👍

Replace RV Residential Refrigerator Mounting Brackets

During this tight budget month, is there any way to replace the mounting brackets on my GE residential refrigerator for under $100? The bracket that secures the fridge broke (as shown in the attached picture) during our last trip, and now I'm worried about it shifting around while we're driving.

I've been searching everywhere online but I'm not having any luck finding the exact part. Are these brackets something universal that I can get from RV parts suppliers, or do I need to go directly through GE? I'm also wondering if there's a way to fabricate something myself if I can't find the original part.

Any guidance on where to look or what my options are would be hugely appreciated - we have a trip planned next month and really need to get this fixed! …more
How to Find Ford Dealers That Service RV Chassis
Engine Easy N/A - research 298 👍

How to Find Ford Dealers That Service RV Chassis

Staring at my broken-down F53 motorhome with a list of Ford dealers, having no clue which ones actually know how to work on RV chassis. When I was in Knoxville, TN, I encountered several issues including an intermittent engine misfire, a missing front suspension bumper, and a completely missing rear sway bar mount.

I've been calling around to Ford dealerships and most either refuse or say they don't have anyone qualified to work on these chassis. The few places I found are booking months out, which makes me nervous about emergency repairs.

My experience with Paul Miller Ford in Lexington, KY was excellent. Mike, their motorhome advisor, got me in quickly. They diagnosed a burned plug wire, ordered parts, and had me back on the road in just a few days.

Is there a better way to identify which Ford dealers are actually equipped and willing to service RV chassis? I want to make sure I find reputable places before I actually need them. …more

Need a second opinion?

Not sure if this applies to your rig? An RV technician can confirm the fix for your specific make and model.

Ask an RV Expert
27708 RV owners helped · Avg response under 5 min
Max's Vinyl Decal Restorer Review - RV Graphics Results
Exterior Easy 2-3 hours for application 296 👍

Max's Vinyl Decal Restorer Review - RV Graphics Results

About to give up on Max's Vinyl Decal Restorer after treating my faded RV graphics yesterday — they still look dull and lifeless, did I mess something up? You know the drill - see something on social media, think "this is THE ONE," order it with way too much hope, and usually end up disappointed.

Well, I just tried Max's Vinyl Decal Restorer after seeing it recommended online. I prepped the graphics with Soft Scrub and a big sponge (nothing too harsh), then applied a few coats of Max's. The results aren't "like new" but definitely a great improvement over the sad, sun-beaten decals I started with.

Here's the real test though - after application, my RV survived a week of solid rain, then a week of camping, followed by a full soapy wash. And the graphics STILL look good! Has anyone else tried this stuff? Am I getting my hopes up for nothing, or did I actually stumble onto something that works? …more
How to Replace Onan 10KW Generator Isolation Mounts: Complete RV Repair Guide
Engine Hard 2-4 hours 290 👍

How to Replace Onan 10KW Generator Isolation Mounts: Complete RV Repair Guide

My 2013 Tiffin Allegro Bus generator (model 10HDKCA11506E) is producing violent shaking and a grinding noise that's absolutely driving me insane. The isolation mounts keep wearing out way too quickly - I just had them replaced 19 months ago and they're already shot again.

Last repair used parts #402-1680-02, but my Onan parts manual shows I should have 2x #402-0728-01 and 2x #402-0728-02 isolators. The generator only has 34 hours since the last mount replacement, and symptoms are obvious - excessive noise, vibration throughout the coach, and the oil drain plug hanging below the frame.

What's the proper way to replace these mounts? Are the parts I'm seeing actually interchangeable, or did the shop potentially use incorrect components? I'm tired of this recurring problem and need a solution that will actually last. …more
Robert, RV Mechanic
Ask an RV Mechanic Avg reply < 5 min

My Rig Settings

Hi, I'm Hank!
Need help setting up? I can walk you through it
Rig Info
Give it a name you'll recognize
Power & Electrical
Climate Control
Water System
Refrigerator Type
Leveling System
Convenience & Features
Sync across devices

Rig Saved to Cloud

Your sync code (use this to load your profile on another device):

Write this down! There is no way to recover it if you lose it and clear your browser.