When Power Gear levelers won't retract but deploy normally, the issue is typically a faulty retract solenoid valve, damaged wiring, or control module failure. This comprehensive guide provides step-by-step troubleshooting to identify and fix the problem.
When your RV slide out motor runs but won't retract, it's typically a hydraulic system issue like low fluid, air in lines, or a faulty valve. Cable systems may have broken cables or stripped gears.
RV slide out water leaks typically occur due to worn weatherstripping, clogged weep holes, or misaligned seals. Start by inspecting the top seal and corners, then check drainage systems and side seals systematically.
Keep your RV slide-outs working reliably with this comprehensive maintenance and repair guide.
Slideout rubbing wall with smaller bottom gap suggests drooping - worn lower rollers or adjustment needed. Inspect rollers, check mounting bolts, and look for floor damage underneath.
Lippert slide motor parts available from lci1.com, PPL Motorhomes, or RV parts suppliers. Motor only or complete gearbox options. Diagnose whether motor or gears failed to determine best replacement approach.
You can replace a failed Atwood Levelegs control system with a GAMA Electronics RF340-4PR-ASL controller for around $235, which is much cheaper than OEM replacement or repair. This aftermarket solution provides better reliability and easier troubleshooting than the original Atwood system.
Lift slideouts for floor repair using bottle jacks and blocks under the extended slide frame, or a come-along from inside. Never rely solely on hydraulics - always use mechanical blocking.
Motor should run in Store mode for HWH jacks. If jacks extend but not retract, likely the retract solenoid valve or its wiring. Spring replacement should not affect hydraulic function unless lines were disturbed. Contact HWH for technical support.
When HWH 325 levelers turn off immediately after pressing extend buttons, it's typically caused by low voltage under load, loose connections, or a faulty control module. Check battery voltage under load and inspect all connections first.
When your HWH 625S slide solenoids work manually but not from the switch, the issue is likely in the control box wiring or internal components. You can bypass the control box by connecting switch wires directly to solenoid wires, but proper diagnosis should be done first.
Slide bottom leaks when retracted are from bottom wiper seal not making proper contact. On a 2023 unit, this is warranty work. Document with photos and contact your dealer.
Light hydraulic weeping without drips or jack sag is often normal fitting seepage. Clean, monitor, and snug fittings slightly. Worry if jacks sag or you see active drips.
Levelegs and air suspension are separate systems. If coach wont raise, check that levelers are fully retracted, air compressor is running, and no air leaks. May need professional service if stuck low. Do not drive with suspension issues.
Yes, HWH systems typically use 1/4" ID hydraulic hose. You can repair with a compression coupling, but you'll need to bleed the system afterward. This is a moderate DIY repair if you have the right tools and fittings.