The RC7-GS inverter charger can properly charge 105Ah AGM batteries using the 125Ah setting, as AGM charging is voltage-based, not capacity-dependent. Generator start issues typically stem from wiring problems or incorrect DIP switch configurations.
Master your RV electrical system from house batteries to shore power. Covers 12V DC, 120V AC, inverters, and charging.
An E1 error on your MPPT solar controller typically indicates a battery over-voltage condition or wiring fault. This comprehensive guide shows you how to diagnose and fix the issue safely, including when professional help is needed.
Fix your RV refrigerator with this guide covering Dometic, Norcold, and residential fridge issues.
Most RV solar systems range from 200-800 watts using 12V panels wired in parallel with PWM or MPPT controllers. Wire gauge depends on amperage and distance, with 10-12 AWG typical for most installations.
Dual purpose lithium batteries work for coach use but dedicated deep cycle lithium is better for house banks. Dual purpose compromises between starting and cycling. For RV house batteries, deep cycle LiFePO4 provides better value and cycle life.
Your Progressive Dynamics converter needs either a lithium-compatible charge wizard upgrade (PD9160ALV) or complete replacement with a modern lithium-capable charger like the AIMS or Progressive Dynamics PD9200 series.
Low amp charging from solar panels is typically caused by loose connections, incorrect controller settings, or battery issues rather than a bad controller. Start by checking all wiring connections and battery voltage before replacing the charge controller.
LiFePO4 lithium batteries like the Dyness can replace lead acid batteries, but you'll likely need to upgrade your converter/charger to a lithium-compatible model. The BMS protects the battery from overcharging and provides longer life with faster charging.
Install low voltage disconnect relay in line feeding Ecoflow alternator charger. Victron Battery Protect or similar cuts power at set voltage. Set disconnect at 12.8V for LiFePO4 to stop at about 20% remaining capacity.
A wireless RV backup camera showing no signal is typically caused by power issues, loose connections, or wireless interference. Start by checking camera power, verifying monitor settings, and testing connections systematically.
Keep your RV comfortable in any weather with this AC, furnace, and heat pump troubleshooting guide.
Yes, you need a DC-DC charger to safely charge your lithium battery from your truck's alternator. Installing one between your truck's charge line and battery will prevent alternator damage and provide optimal lithium charging.
Check LiFePO4 at rest - 13.2-13.4V is full. Clean panels, check all connections for corrosion, verify charge controller is set for lithium. 2150W solar should charge easily if system is working.
Sawtooth patterns in Victron MPPT readings are often normal during float charging. The controller pulses current to maintain voltage. Check if battery is charging properly - if so, patterns are normal.