Results for "Thor"

Exterior Medium 3-4 days (includes curing time) 236 👍 1

DIY RV Basement Door Paint Repair: Complete Guide & Cost Analysis

Despite protecting my RV all winter, those brutal summer months have absolutely destroyed the paint on my four basement doors and rear wheel area across 2' x 20', leaving me staring at a $5,000-6,500 shop estimate versus DIY with my compressor. I've never done automotive paint work before. Could I really achieve decent results for under $500 like I keep reading online? I'm concerned about proper paint matching, whether I'll damage the surface during prep, and if I choose the wrong spray gun or technique.

Has anyone successfully tackled RV exterior panel paint repair as a DIY project? I need reassurance that this is actually doable without professional training, and guidance on the complete process from start to finish. …more

Read answer

Electrical Medium 2-6 hours 231 👍 1

ECM Low Battery Warning RV: Complete Diagnosis & Fix Guide

During a family trip, my 2005 Fleetwood Discovery 39S threw code 168-1 for low ECM battery voltage and went into full shutdown mode—is this dangerous with kids onboard? Engine cut out, transmission selector went dark, ABS warnings everywhere - the whole nine yards. Scared the heck out of me when it happened on the interstate!

I'm seeing this seems to be a thing with these diesel pushers, but I'm drowning in conflicting info online. Some say it's the chassis battery, others blame alternator issues, and I've even seen posts about ECM power supply problems on the Caterpillar engines. What's the actual step-by-step process to track this down? And more importantly, how do I fix it so it doesn't leave me stranded again? Really need a complete walkthrough of what causes this code and the proper repair approach. …more

Read answer

General Medium 1-2 days for initial setup 220 👍 1

RV Storage on Gravel: Preventing Weed and Moisture Issues

Nobody warned me that buying a house with RV storage meant inheriting the previous owner's 13-year-old weedy, muddy gravel disaster. While considering this location's storage options, I want to mitigate potential issues with weed growth and moisture retention under the RV.

I'm seeking advice on effective strategies for storing on a gravel surface that shows significant weed penetration and moisture retention. Initial ideas include pre-treatment herbicide application and installing a protective barrier, but I want input from experienced RV owners.

My primary concerns are preventing undercarriage damage and managing moisture/vegetation growth. I plan to spray weed killer beforehand and potentially lay down a weed barrier, pending facility approval. What techniques or materials do you recommend to protect my RV during storage? …more

Read answer

Product Ranking 8 compared

Best RV Solar Panel Kits

4.5 (12,700 reviews)

Exterior Hard 2-8 hours for temporary fix, 1-5 days for permanen 213 👍 1

RV Sidewall Blistering & Delamination Repair Guide 2024

According to three different RV shops, fixing my bubbling sidewall delamination will cost thousands, but I'm wondering if tackling this DIY repair myself is actually feasible. My 2004 Itasca Sunova has decided to sprout some lovely blisters on the right sidewall - two beauties that are about 12-14 inches long and 3-4 inches wide, running vertically right behind the awning arm. Perfect timing since we're currently on the road living our best RV life!

I'm pretty sure water snuck in somewhere (probably from the roof rail or that shower skylight we never use), and now my RV looks like it's got chicken pox. Since we can't exactly pull into the nearest RV surgeon's office, I need to know: what can I do right now to stop this from getting worse, and what's involved in actually fixing this mess properly? I'm hoping there's some kind of emergency containment plan that doesn't involve duct tape and prayers! …more

Read answer

Engine Easy 45 min 196 👍 0

Femco vs Fumoto Oil Drain Valves for RVs - Which is Better?

Looked at my mechanic's quote for a $300 professional oil change setup and something seems off—wouldn't a basic Femco or Fumoto drain valve work just fine? I've narrowed it down to Femco and Fumoto, but I'm genuinely worried about road debris damage since RVs sit lower and encounter more hazards than regular vehicles.

The thought of a drain valve getting hit by rocks or debris and causing a catastrophic oil leak on the highway keeps me up at night. I need to know which design is actually safer and more protected in RV applications. Does one have better protection features than the other? I'd rather be overly cautious than deal with a roadside emergency. …more

Read answer

Engine Hard 2-3 hours for diagnosis 172 👍 0

1999 F53 V10 Oil in Coolant: Complete Head Gasket Diagnosis & Repair Guide

Called three dealerships about warranty coverage for oil contamination in my 1999 Ford F53 V10's coolant system — before I tackle this head gasket nightmare myself. The unit overheated after the oil level dropped significantly, though it still starts and runs without throwing any codes.

Based on the symptoms, I suspect a blown head gasket, but I want to perform proper diagnostic testing before committing to a major repair. What specific diagnostic procedures should I run to confirm whether this is actually a head gasket failure versus other potential causes like a cracked head or block issue?

Looking for a systematic approach to pinpoint the exact problem before I start tearing into this engine. …more

Read answer

Engine Hard 4-6 hours 171 👍 0

Ford F53 7.5L RV Won't Start: Fuel Pump Relay Voltage Drop Fix

Woke up to my 1996 Ford F53 7.5L motorhome eating through my patience and wallet with this no-start issue that keeps coming back. It cranks strong but absolutely will not start, and I've been chasing this problem for weeks now. The engine ran fine for about 3-4 minutes one day, then just died and hasn't started since.

I've already done quite a bit of diagnostic work:
- Replaced PCM and distributor
- Fuel pump works when powered directly
- Battery is fully charged
- Checked fuses and relays
- PCM relay voltage drops from 12.2V to 9.3V with key on
- Fuel pump relay only shows 3.3V at pin 86 (should be 12V)
- Inertia switch tested at 1.7V at connector
- ANL 178 fusible link fluctuates between 0.3-0.6V

The engine will only start with starter fluid when the SPOUT is removed. I'm getting only 5.5V at the fuel pump connector.

Has anyone dealt with this specific issue on an F53 chassis? I really need to get this RV back on the road and I'm running out of ideas! …more

Read answer

Plumbing Medium 1-2 hours 169 👍 0

Monaco Diplomat Rear Air Suspension Won't Dump Fully - Troubleshooting Guide

Last week my 2006 Monaco Diplomat's rear air bags started refusing to dump all the way down when I hit the air dump before leveling. The front dumps fine, but the back stays partially inflated.

I'm still pretty new to RV maintenance and not sure where to start troubleshooting this. Should I be hearing air escaping when I activate the dump? What are the most common causes when rear air bags won't dump completely? Any guidance on what to check would be really appreciated! …more

Read answer

Plumbing Easy 10 minutes 169 👍 0

Camco Rhino Sewer Hose Adapter Pro: Complete Review & Installation Guide for RV Owners

Noticed my 2018 Forest River Cherokee's cheap sewer hose adapter keeps leaking at the connection no matter how tight I make it. The Camco Rhino Sewer Hose Adapter Pro claims it works on both threaded and non-threaded outlets with some kind of clamp system, but I'm worried about spending money on something that might not actually work reliably.

Has anyone actually used this adapter successfully? I'm particularly concerned about whether the clamp system really creates a leak-resistant seal, and if it truly eliminates the need to carry multiple adapters. My RV has a non-threaded outlet and I've had nothing but problems with adapters that don't fit securely or leak during dumping. …more

Read answer

Exterior Medium 2-4 hours 167 👍 0

RV Rubber Roof Bubbling? How to Repair EPDM Separation

After 8 years of faithful service, my RV's EPDM rubber roof is starting to bubble with the membrane separating underneath — should I repair or replace? I'm concerned that if I don't address this soon, water could get in and cause major damage.

But I'm also nervous about trying to fix it myself. What if I make it worse by cutting into the roof or using the wrong products? Is this something that can actually be repaired, or am I looking at a full roof replacement? I'd really appreciate some guidance on whether this is a DIY-friendly repair and what the basic process involves. …more

Read answer

Engine Easy N/A 164 👍 0

Ford V10 Triton Engine Maintenance Guide: EGR Delete vs Regular Service Tips

Spent years doing regular EGR maintenance on my old gas motorhome without issues — but this 2007 Fleetwood 31' Tioga with Ford V10 Triton has me second-guessing everything. I keep reading conflicting information about EGR delete procedures on V10 engines, and I'm worried I might make things worse if I mess with it.

Is the EGR delete modification actually necessary on this 2007 3-valve V10, or am I overthinking this? I don't want to void any warranties or create problems that weren't there before. Would I be better off just sticking to regular maintenance instead of modifications? I'm looking for reassurance that I'm taking the right approach to keep this engine running reliably for years to come. …more

Read answer

Product Ranking 8 compared

Best RV Surge Protectors

4.6 (14,200 reviews)

Plumbing Medium 2-3 hours 162 👍 1

Dometic 310 Toilet Leaking at Foot Pedal: Complete Fix Guide

Called my weekend camping trip short because my Dometic 310 toilet has water pooling underneath, the flush mechanism sticking, AND that annoying gurgling sound happening constantly. I can see the leak between the fixed outer part and the moving pivot section when the pedal is pressed.

Already replaced the toilet valve but it's still leaking from the same spot. The inlet and outlet hoses look fine. What causes leaks at the pedal mechanism itself after the valve has been changed? …more

Read answer

Exterior Medium 2-3 hours 161 👍 1

How to Replace RV Slide Topper Fabric: Complete DIY Guide 2024

I pulled into three different campsites this month and my torn slide topper is eating through my gear faster than I can replace it. I've never done anything like this before and I'm worried I might damage the whole mechanism or make things worse.

Can I actually replace just the fabric portion safely, or should I bite the bullet and have the entire assembly replaced by a professional? I'm also concerned about costs - I'm hoping this won't break the bank. If it is something I can do myself, how difficult is it really? I don't want to get in over my head and end up with a bigger problem than I started with.

Can you help me understand the best approach for my specific situation? …more

Read answer

Engine Hard Not recommended 159 👍 0

Ford V10 Turbo Kit for Motorhomes: Cost, Risks & Better Alternatives

Before every camping season rolls around, I face the same dreaded reality with my Ford V10 motorhome crawling up mountain passes like a wounded turtle. What are the realistic costs involved? Are there major risks to the engine I should know about? Is this actually worth doing or should I look at other options? …more

Read answer

Exterior Medium 30-60 min 155 👍 1

Kwikee RV Steps Not Working? Complete Troubleshooting Guide (2024)

Apparently we're leaving for a three-week cross-country trip next Monday and my Kwikee electric RV steps are still having intermittent retraction issues even after replacing both the gear box and motor. My steps are exhibiting intermittent retraction issues - they extend normally but require manual assistance to retract fully, stopping approximately a quarter inch through the cycle without intervention. I've already installed a new gear box and motor, yet the problem persists.

What systematic diagnostic approach should I follow to identify the root cause? I need to understand the complete troubleshooting sequence for motor functionality, electrical switch operation, and mechanical linkage components. Are there specific voltage measurements, resistance checks, or mechanical adjustments that should be performed to isolate whether this is an electrical or mechanical failure?

Thanks,
Pete …more

Read answer

Loading more Q&A...

You've seen all 321 Q&A articles!