Results for "shaft length"

Walked out to prep our RV this morning and discovered our Lippert Power Gear slide motor is making grinding noises and won't extend properly. My RV's slide motor is failing and I'm trying to figure out the best way to get replacement parts. The slide is getting sluggish and I suspect it's either the motor brushes or possibly something in the gearbox itself.

I've been searching everywhere for Lippert Power Gear parts but I'm not sure where to look or what my options are. As it stands, the replacement parts are ridiculously expensive - a $100 gearbox, $50 brake, and $100 motor, but Lippert wants nearly $1000 for the whole assembly. I just want to replace the brushes, but they won't even sell those separately!

Can I buy just the motor component, or do I need to replace the entire gearbox assembly? I really need to know where I can actually purchase these parts and how to determine whether it's a motor issue or a gear problem before I spend a fortune on the wrong repair! …more

Nobody told me what steering play should feel like on a 2022 Newmar Bay Star 3609 with 11k miles, and I'm worried these issues aren't normal. The coach has Liquid Springs and a Safe T Plus steering stabilizer that were professionally installed right after delivery, so I expected the steering to be really tight.

However, the owner mentioned there's still noticeable steering wheel play, and when I looked at the tires, the outer edge of the right front is significantly worn while the left front looks perfectly even. For such low mileage, this seems concerning to me. The owner says he gets annual alignments done professionally, so if it's not alignment causing this, what else could it be?

I'm worried there might be something seriously wrong with the chassis or steering components that could be dangerous or expensive to fix. Am I being overly cautious, or are these red flags I should walk away from? I really don't want to buy someone else's problem, especially when it comes to steering safety. …more

Replaced the wheel alignment on my 2018 Class A motorhome and now the steering wheel is sitting crooked — should I fix it myself or go back? I have an RV with an F53 chassis, and after getting an alignment, my steering wheel sits crooked when I'm driving straight - it's off by what looks like 30-45 degrees to the right. The RV tracks straight down the road just fine, but having to hold the wheel at an angle is driving me absolutely crazy on long trips.

I know this chassis uses an older steering system similar to what was used in the 1920s, and from what I understand, the drag link isn't adjustable. I've already installed a big steering stabilizer, but I'm concerned about how this offset might affect the steering box's performance. The steering shop seems busy, and I'm worried they'll just brush me off or charge me again. Is there a good way to center the steering wheel without major mechanical intervention? I really need to get this sorted out before our next big trip - any advice would be hugely appreciated! …more

The Trek motorhome's water pump just died at 11 PM in the middle of nowhere — need to figure this out before morning. While returning from Assateague, just north of Smyrna, Delaware, my water pump failed with a cloud of steam, leaving me stranded on the side of the road. Thankfully, Coach-Net, our road service provider, found us a tow to Lube Station and Repair in Smyrna. The Delaware State Police and Smyrna Fire Department were incredibly helpful, checking on us during this stressful situation. We ended up staying the night in the shop's lot and made it home only a day late. Has anyone else experienced something similar and have advice for handling roadside RV emergencies? …more

Apparently this Coleman Mach 10 AC motor replacement is eating through my entire weekend because the new shaft is way too long for my Winnebago Era. The new motor shaft is way too long compared to what I'm seeing in YouTube videos of other Coleman units. The old blower wheel is stuck tight on the original shaft too - thing won't budge!

Anyone dealt with this before? Do I need to trim the shaft somehow, or is there a better way to handle the length issue? And what's the trick for getting that stubborn blower wheel off without wrecking everything? …more

Somewhere between last month's slightly low oil pressure reading on my '91 Ford E350 460 engine and today's complete engine knocking, I'm thinking this oil pump is finally dying.

Here's the weird part - oil pressure gauge sits really low (like concerningly low) but the temp gauge never even hits the middle, stays cool as a cucumber. She runs like a total champ though, starts every time, smooth as butter, pulls hills no problem. Just hit 99k miles and put about 7k on her this year with zero issues performance-wise.

Everything I'm reading online says oil pump problems usually show up as low pressure AND high temps together. But I've got low pressure with low temps, which seems backwards? Had one moment recently where the oil pressure suddenly jumped to normal mid-range after smelling some hot oil at a gas stop. Is this actually pointing to oil pump failure, or am I maybe looking at faulty gauges or sending units instead? …more