Results for "screen removal"

Our 2019 Fleetwood Discovery LXE has a malfunctioning Firefly multiplex control panel that needs to be completely removed. I've been putting this off for months because I keep hearing horror stories about people cracking their panels or damaging the surrounding woodwork during removal.

I need to access the back of the unit for some electrical work, but I'm honestly terrified of breaking something expensive. The panel seems to be mounted flush with no obvious screws or clips visible from the front. I've searched everywhere but can't find a complete walkthrough that covers the preparation, actual removal process, and how to get everything back together properly.

Can someone please provide a detailed DIY guide that covers all the steps? I'm willing to take my time and do this right - I just need to know the proper technique so I don't end up with a broken control panel or damaged wall. …more

Last week my pressure regulator started reading a solid 40 PSI on city water but my water pump keeps cycling on for 5-6 seconds when everything says it should stay completely off. When I connect to city water, my water pressure regulator shows a solid 40 PSI, which should be plenty, right? But here's the weird part - my water pump keeps kicking on for about 5-6 seconds then shuts off, even though I'm connected to city water and the pump switch is supposed to be off.

The really frustrating thing is that the pressure feels weak throughout the RV, with specifically the bathroom sink and kitchen sink seeming low, though the shower has good pressure. I've already changed out the intake/check valve and don't currently have a filter in the system. I can see the pump running while on city water, which I know is not normal. I noticed the kitchen and bathroom sink screens were plugged - which might explain some pressure issues - but now I'm wondering about the toilet's low pressure. Could there be a screen in the toilet line I'm not seeing?

I've been full-timing for two years and never had this issue before. What should I be checking for? I'm handy enough to do basic repairs but need to know where to focus my troubleshooting efforts. …more

Since it's 2 AM and I need to hit the road at dawn, I'm desperately trying to figure out if balance beads will interfere with my RV's internal TPMS sensors. I keep reading about how great balance beads are for eliminating wheel vibration, but I'm terrified of damaging those expensive TPMS sensors inside the wheels.

What if the beads hit the sensors and break them? Or interfere with the signal? I can't afford to replace TPMS sensors if something goes wrong. Has anyone actually done this successfully, and are there special precautions I need to take with bead size or how they're installed? I need to know this is safe before I risk it. …more

According to my troubleshooting so far, I've replaced the fuel filter, cleaned the fuel lines, checked all the connections, and even swapped relays — but my 1999 Pace Arrow F53 still won't get fuel to the engine. The original fuel pump has been operational for 27 years, exposed to gasoline storage conditions throughout this period.

Given the extended service life and potential for roadside failure, I'm evaluating whether proactive fuel pump replacement represents sound maintenance strategy. Seeking technical assessment on replacement timing and expected performance outcomes with quality aftermarket units from established suppliers.

What are the documented results from similar preventive fuel pump replacements on this chassis configuration? Is the investment in preemptive replacement justified based on reliability data? …more

Halfway through our camping trip, my Onan 4KY-26100R generator on a 2018 Winnebago Spirit is doing something bizarre — firing up perfectly after running out of gas but dying within minutes. After refilling the tank and changing the oil, the generator starts but immediately shuts off when I release the start switch. Getting 3 flashes on the control switch indicating service required. Oil level is correct - halfway between add and full marks. Is this an air in fuel system issue from running out of gas? How long should I hold the start switch to get it running again? …more

Called off work Friday to tackle a deep RV window cleaning project this weekend — what's the safest way to remove these screens without snapping them? There don't seem to be any obvious screws holding it in place. What's the proper way to take out RV window screens for cleaning access? …more

Nobody wants to hear that subtle whining noise coming from their RV's 4R100 transmission with a V10 engine, but here I am wondering if a spin-on filter conversion kit installation might help. My mechanical skills are about as reliable as my RV's slideouts in a rainstorm, but I keep hearing these kits make filter changes easier than finding a level campsite.

I'm seeing all these different kit options online and honestly feeling more confused than a GPS in a tunnel. Do these spin-on filters actually mount in the cooler line (which I believe is a full flow system)? I'm specifically looking for a filter under 10 microns that works with my transmission setup. Are these supposed to work alongside the existing internal filter, or am I about to create an expensive science experiment under my rig? Because let's be real - my track record with 'simple' RV modifications usually ends with me calling a professional and pretending I never touched anything. …more

Looked everywhere online but still trying to decide between a fuel pump issue or ECM problem for my 1989 Ford Tioga 460 EFI that won't start after jumping the dead battery. The RV ran smoothly for weeks until I had to jump-start it after leaving lights on overnight. After the jump, the engine fired but immediately died - completely different behavior than its previous reliable starts.

The engine will only stay running when fuel is manually added to the intake, suggesting a fuel delivery problem. Prior to this incident, the fuel system worked flawlessly. The timing correlation between the dead battery jump-start and the fuel system failure seems significant.

What are the most likely causes when a 460 EFI system loses fuel delivery immediately after a battery jump? Could the jump-start procedure have damaged fuel system components, and what should I check first in the fuel pressure circuit? …more

Somewhere between last month's slightly low oil pressure reading on my '91 Ford E350 460 engine and today's complete engine knocking, I'm thinking this oil pump is finally dying.

Here's the weird part - oil pressure gauge sits really low (like concerningly low) but the temp gauge never even hits the middle, stays cool as a cucumber. She runs like a total champ though, starts every time, smooth as butter, pulls hills no problem. Just hit 99k miles and put about 7k on her this year with zero issues performance-wise.

Everything I'm reading online says oil pump problems usually show up as low pressure AND high temps together. But I've got low pressure with low temps, which seems backwards? Had one moment recently where the oil pressure suddenly jumped to normal mid-range after smelling some hot oil at a gas stop. Is this actually pointing to oil pump failure, or am I maybe looking at faulty gauges or sending units instead? …more