Results for "oil-change"

Exterior Medium 3-4 days (includes curing time) 236 👍 1

DIY RV Basement Door Paint Repair: Complete Guide & Cost Analysis

Despite protecting my RV all winter, those brutal summer months have absolutely destroyed the paint on my four basement doors and rear wheel area across 2' x 20', leaving me staring at a $5,000-6,500 shop estimate versus DIY with my compressor. I've never done automotive paint work before. Could I really achieve decent results for under $500 like I keep reading online? I'm concerned about proper paint matching, whether I'll damage the surface during prep, and if I choose the wrong spray gun or technique.

Has anyone successfully tackled RV exterior panel paint repair as a DIY project? I need reassurance that this is actually doable without professional training, and guidance on the complete process from start to finish. …more

Read answer

Engine Hard 2-3 hours for diagnosis 172 👍 0

1999 F53 V10 Oil in Coolant: Complete Head Gasket Diagnosis & Repair Guide

Called three dealerships about warranty coverage for oil contamination in my 1999 Ford F53 V10's coolant system — before I tackle this head gasket nightmare myself. The unit overheated after the oil level dropped significantly, though it still starts and runs without throwing any codes.

Based on the symptoms, I suspect a blown head gasket, but I want to perform proper diagnostic testing before committing to a major repair. What specific diagnostic procedures should I run to confirm whether this is actually a head gasket failure versus other potential causes like a cracked head or block issue?

Looking for a systematic approach to pinpoint the exact problem before I start tearing into this engine. …more

Read answer

Engine Hard 4-6 hours 171 👍 0

Ford F53 7.5L RV Won't Start: Fuel Pump Relay Voltage Drop Fix

Woke up to my 1996 Ford F53 7.5L motorhome eating through my patience and wallet with this no-start issue that keeps coming back. It cranks strong but absolutely will not start, and I've been chasing this problem for weeks now. The engine ran fine for about 3-4 minutes one day, then just died and hasn't started since.

I've already done quite a bit of diagnostic work:
- Replaced PCM and distributor
- Fuel pump works when powered directly
- Battery is fully charged
- Checked fuses and relays
- PCM relay voltage drops from 12.2V to 9.3V with key on
- Fuel pump relay only shows 3.3V at pin 86 (should be 12V)
- Inertia switch tested at 1.7V at connector
- ANL 178 fusible link fluctuates between 0.3-0.6V

The engine will only start with starter fluid when the SPOUT is removed. I'm getting only 5.5V at the fuel pump connector.

Has anyone dealt with this specific issue on an F53 chassis? I really need to get this RV back on the road and I'm running out of ideas! …more

Read answer

Product Ranking 8 compared

Best RV Awnings & Accessories

4.5 (7,600 reviews)

Engine Easy N/A 164 👍 0

Ford V10 Triton Engine Maintenance Guide: EGR Delete vs Regular Service Tips

Spent years doing regular EGR maintenance on my old gas motorhome without issues — but this 2007 Fleetwood 31' Tioga with Ford V10 Triton has me second-guessing everything. I keep reading conflicting information about EGR delete procedures on V10 engines, and I'm worried I might make things worse if I mess with it.

Is the EGR delete modification actually necessary on this 2007 3-valve V10, or am I overthinking this? I don't want to void any warranties or create problems that weren't there before. Would I be better off just sticking to regular maintenance instead of modifications? I'm looking for reassurance that I'm taking the right approach to keep this engine running reliably for years to come. …more

Read answer

Exterior Medium 2-3 hours 161 👍 1

How to Replace RV Slide Topper Fabric: Complete DIY Guide 2024

I pulled into three different campsites this month and my torn slide topper is eating through my gear faster than I can replace it. I've never done anything like this before and I'm worried I might damage the whole mechanism or make things worse.

Can I actually replace just the fabric portion safely, or should I bite the bullet and have the entire assembly replaced by a professional? I'm also concerned about costs - I'm hoping this won't break the bank. If it is something I can do myself, how difficult is it really? I don't want to get in over my head and end up with a bigger problem than I started with.

Can you help me understand the best approach for my specific situation? …more

Read answer

Exterior Medium 30-60 min 155 👍 1

Kwikee RV Steps Not Working? Complete Troubleshooting Guide (2024)

Apparently we're leaving for a three-week cross-country trip next Monday and my Kwikee electric RV steps are still having intermittent retraction issues even after replacing both the gear box and motor. My steps are exhibiting intermittent retraction issues - they extend normally but require manual assistance to retract fully, stopping approximately a quarter inch through the cycle without intervention. I've already installed a new gear box and motor, yet the problem persists.

What systematic diagnostic approach should I follow to identify the root cause? I need to understand the complete troubleshooting sequence for motor functionality, electrical switch operation, and mechanical linkage components. Are there specific voltage measurements, resistance checks, or mechanical adjustments that should be performed to isolate whether this is an electrical or mechanical failure?

Thanks,
Pete …more

Read answer

Ac Refrigeration Medium 2-3 hours 128 👍 0

Dometic RV AC Not Cooling? 5 Common Fixes for Air Conditioner Troubleshooting Guide

Walked out to my RV this morning trying to decide between calling a repair tech or troubleshooting my Dometic Brisk Air rooftop AC myself since it's showing weird operational issues. The compressor engages and fan motor operates normally, but the unit fails to produce cold air output. Temperature differential across the evaporator coil is minimal.

Unit functioned properly through previous cooling season with no apparent issues. Current symptoms include normal airflow volume but inadequate cooling capacity. What systematic diagnostic procedure should I follow to identify the root cause? Looking for a methodical troubleshooting sequence that addresses the most probable failure points in order of likelihood. …more

Read answer

Slideouts Medium 2-3 hours 115 👍 0

RV Slide Out Moving Slowly? Complete Lubrication & Repair Guide [2024]

I tried everything I could think of, but after all that heavy rain last week, my slide out went from smooth operation to moving like molasses. It sounds like it's really struggling and straining, making these awful grinding noises that have me worried I'm going to break something expensive.

I've been reading that lubrication might be the answer, but I honestly don't know where to start. Should I be looking at the motor mechanism? The tracks? I've heard about hydraulic fluid but I'm not sure if my system is hydraulic or electric. I really need someone to walk me through what needs lubrication and what else I should check before this thing stops working completely!

Could you help me troubleshoot? Details that might help: Can you tell me the specific model of my RV and the type of slide out system it uses? …more

Read answer

Electrical Medium 45 minutes 113 👍 0

RV Shore Power Not Working: Complete Troubleshooting Guide

Plugged into shore power at the campground last night and absolutely nothing happened — no lights, no AC, nothing. Breaker on the pedestal looks fine and my neighbor's rig is running perfectly on the same circuit. Starting to wonder if something fried inside the transfer switch. …more

Read answer

Engine Hard Professional repair required 112 👍 0

Ford F53 V8 Engine Tapping Noise: Complete TSB 25-2200 Repair Guide for RV Owners

Since I replaced the valve cover gaskets on my 2022 motorhome's Ford F53 V8 yesterday, I'm still hearing that annoying tapping noise — did I miss something? I've been noticing this tapping or ticking sound when the engine is idling, and sometimes it seems to run a bit rough. I'm worried I might have a serious problem.

I found a Ford Technical Service Bulletin (TSB 25-2200, NHTSA ID 11018524) that might be related to my issue. The bulletin mentions potential camshaft and valve tappet wear causing ticking noises, rough performance, and diagnostic trouble codes P0301-P0308. According to the bulletin, repairs might even include a new long block.

Can someone help me understand what this TSB covers exactly? Does it apply to my specific year model, and what kind of repairs might be needed? I'm hoping this might be something covered under warranty since the RV is still pretty new to me.

Any guidance would be really appreciated - I'm still learning about all this mechanical stuff! …more

Read answer

Ac Refrigeration Medium 45 minutes 109 👍 0

How to Fix a Squeaking Dometic Fan-Tastic Roof Fan in Your RV

Looked up at my Dometic Fan-Tastic roof fan squeaking loudly above my kids' beds—is this dangerous or could something actually break and fall on them? The fan blades aren't hitting the housing, so that's not the issue. What are the most common causes of squeaking in these roof fans? Is this something I can fix myself with basic maintenance, or does it usually require replacing parts like bearings or the motor? …more

Read answer

Product Ranking 8 compared

Best RV Batteries

4.5 (15,400 reviews)

Electrical Medium 2-4 hours 105 👍 0

How to Protect Your RV Alternator When Charging Lithium Batteries: DC-

Tried everything my neighbor did to charge his LiFePO4 batteries but mine keeps frying the alternator while his works flawlessly — what's different? I want to install a temperature sensing device that can interrupt charging by opening the solenoid between chassis and house charging systems if the alternator gets too hot. I'm looking to spec out components and understand the installation process, and I'm open to hearing why this might not be a good approach. My goal is preventing alternator overheating when these lithium batteries draw high current compared to my old flooded or AGM batteries. I'm looking for technical feedback and am totally open to critique. …more

Read answer

Exterior Medium 2-3 hours 100 👍 0

Dometic 8300 Series Awning Torsion Assembly Replacement Guide (834AV44

Already burned through three Dometic 8300 torsion assemblies in six months and I'm hemorrhaging money as a new RV owner. The model number is 834AV44.138 and I'm not even sure what series this is - is it part of the 8300 series maybe?

The torsion assembly lever broke off and I can't seem to find exact replacement parts anywhere. I'm wondering if there are compatible parts from other Dometic awning models that would work with mine? I don't want to order the wrong thing and make the problem worse. Any guidance on finding the right replacement parts or temporary fixes would be really helpful! …more

Read answer

Engine Medium 2-3 hours 100 👍 0

Ford E-450 RV Shock Absorber Upgrade Guide: Bilstein 4600 vs Koni FSD

Before spending hundreds on new tires and suspension parts for my 2023 Ford E-450 Class C motorhome, the ride quality is still absolutely brutal. The RV is about 28 feet long and weighs approximately 14,500 pounds loaded. We use it primarily for family camping trips, but I also occasionally tow a small utility trailer with dirt bikes - probably 25% of our trips involve towing that extra 2,000-3,000 pounds.

I've been researching shock absorber upgrades and have narrowed it down to two main options that seem popular in the RV community: the Bilstein 4600 series and the Koni FSD (Frequency Selective Damping) shocks. I understand both are significant improvements over stock, but I'm trying to understand the practical differences between them for my specific setup and usage patterns.

What I really need to know is which option provides the best balance of ride comfort improvement, handling stability (especially when towing), and overall value for money on the E-450 chassis. I want to make sure I'm making the right choice since this is a fairly significant investment and I don't want to have buyer's remorse later. …more

Read answer

Chassis Medium 45 minutes 99 👍 0

Dutchstar Chassis Cracking Noise: Diagnosis & Repair Guide

Hearing a loud cracking or popping noise from underneath my Dutchstar when going over bumps or turning. Sounds structural — like metal flexing or a weld breaking. Crawled under and couldn't see any obvious cracks but the noise is getting louder each trip. …more

Read answer

Loading more Q&A...

You've seen all 110 Q&A articles!