Your Onan 5500 generator's fuel pump chatter and dual light illumination indicates a control board communication error triggered by the remote harness connection. This comprehensive guide covers diagnosis, repair steps, and prevention strategies for all common Onan 5500 issues.
Your modified sine wave Xantrex 758 likely caused the hair dryer malfunction due to waveform incompatibility with sensitive electronics. While some devices work fine with modified sine wave inverters, modern residential refrigerators, computers, and electronics require pure sine wave power to prevent damage and ensure proper operation.
When Power Gear levelers won't retract but deploy normally, the issue is typically a faulty retract solenoid valve, damaged wiring, or control module failure. This comprehensive guide provides step-by-step troubleshooting to identify and fix the problem.
When an RV water heater pilot light won't stay lit after releasing the button, it's usually caused by a faulty thermocouple that needs cleaning or replacement. The thermocouple is a safety device that detects the pilot flame and allows gas to flow.
A wireless RV backup camera showing no signal is typically caused by power issues, loose connections, or wireless interference. Start by checking camera power, verifying monitor settings, and testing connections systematically.
Since you have 12VDC at the connector and tried a different module, the door magnetic switch is likely your culprit. You can test it with a multimeter by checking for continuity when the door opens and closes.
External generators need signal wire to trigger ATS, which is only connected to onboard genset. Solutions include manual bypass switch, simulating the run signal, or universal voltage-sensing ATS.
Protect alternator from lithium battery high current draw using DC-DC charger for current limiting or temperature-controlled relay. DC-DC charger is best solution. Direct connection without protection risks alternator failure.
When a Norcold refrigerator starts on propane but shuts off after 1-2 hours, it's typically due to a failing thermocouple, dirty burner, or control board issue. Most problems can be diagnosed by checking the flame appearance and thermocouple connection.
Essential RV tire safety guide covering selection, age limits, maintenance, and when to replace.
Rear brake lights and hazards out often common ground or connector issue. Check grounds at rear lights and chassis-coach junction.
Your MaxxAir/Fantastic fan is likely experiencing a moisture sensor malfunction or rain sensor false trigger. The fix typically involves checking sensor connections, cleaning contacts, or adjusting sensitivity settings.
Yes, balance beads can be used with internal TPMS sensors without damaging them, but there are specific considerations for bead size and installation method. Many RVers have successfully used this combination.
All headlights out with other lights working points to headlight relay or combination switch failure. Check and swap headlight relay first - if no change, the combination switch is likely failed. Common issue on late 90s Ford chassis.
Rear air bags not dumping fully indicates a stuck exhaust valve, check valve issue, or height control valve problem. Listen for air exhausting when dump is activated. Check for obvious blockages and try manually releasing air via Schrader valves on bags.