How to Find Reliable RV Repair Shops: Expert Tips & Red Flags to Watch Out For
Find reliable RV repair shops with research tips, red flags to avoid, and essential questions to ask before authorizing service.
Find reliable RV repair shops with research tips, red flags to avoid, and essential questions to ask before authorizing service.
Keep your RV slide-outs working reliably with this comprehensive maintenance and repair guide.
Lift slideouts for floor repair using bottle jacks and blocks under the extended slide frame, or a come-along from inside. Never rely solely on hydraulics - always use mechanical blocking.
Motor should run in Store mode for HWH jacks. If jacks extend but not retract, likely the retract solenoid valve or its wiring. Spring replacement should not affect hydraulic function unless lines were disturbed. Contact HWH for technical support.
When HWH 325 levelers turn off immediately after pressing extend buttons, it's typically caused by low voltage under load, loose connections, or a faulty control module. Check battery voltage under load and inspect all connections first.
When your HWH 625S slide solenoids work manually but not from the switch, the issue is likely in the control box wiring or internal components. You can bypass the control box by connecting switch wires directly to solenoid wires, but proper diagnosis should be done first.
HWH levelers needing battery reset to work indicates low voltage, loose connections, or controller memory issues. Check battery voltage under load (need 12.4V+), clean and tighten all connections, and verify grounds. Call HWH support if issue persists.
Yes, HWH systems typically use 1/4" ID hydraulic hose. You can repair with a compression coupling, but you'll need to bleed the system afterward. This is a moderate DIY repair if you have the right tools and fittings.
HWH control panel issues often stem from corroded connections or worn switches. Clean connectors first, then consider membrane switch replacement before buying a new $400-800 panel.
When your HWH Spacemaker slide motor runs but won't extend, the most common causes are a faulty extend solenoid, hydraulic leak, or safety lock malfunction. Start by testing solenoid operation and checking for hydraulic fluid leaks at the slide cylinder.
Pump failure after shuttle valve replacement suggests system contamination or air. Debris from failed valve may have circulated through system. Flush system completely, check fluid for particles, and replace filter before new pump.
The electrical manual for your 2007 Dyna Max IE250's Dyna Air Ride suspension is typically found through Monaco Coach Group archives or specialty RV parts dealers, as this was a premium system installed on select Dyna models.
When electric leveling jacks click but won't extend, the issue is typically a blown fuse, low battery power, faulty relay, or hydraulic fluid problem. Start by checking the fuse box and battery connections before moving to more complex diagnostics.
Rear air bags not dumping fully indicates a stuck exhaust valve, check valve issue, or height control valve problem. Listen for air exhausting when dump is activated. Check for obvious blockages and try manually releasing air via Schrader valves on bags.
Your symptoms point to a leak in the rear air bag system or cross-plumbing between tanks. The gurgling sound and faster rear sag indicate air transferring from front to rear tank through a compromised component.