Results for "gaskets"

Ac Refrigeration Medium 2-3 hours 2,222 👍 0

Norcold 1210 Not Cooling: No Error Codes Troubleshooting Guide

During my morning RV check I spotted my Norcold 1210 completely dead with zero cooling that was running perfectly yesterday with no error codes. Unit appears to be operating normally with no error codes displayed, but it's not cooling properly. Interior temperature is staying above 50 degrees. Thermistor has been tested and checks out fine. What else should I look at? …more

Read answer

Engine Hard Not recommended 1,117 👍 0

Ford V10 Turbo Kit for Motorhomes: Cost, Risks & Better Alternatives

Before every camping season rolls around, I face the same dreaded reality with my Ford V10 motorhome crawling up mountain passes like a wounded turtle. What are the realistic costs involved? Are there major risks to the engine I should know about? Is this actually worth doing or should I look at other options? …more

Read answer

Engine Easy N/A 544 👍 0

Ford E-350 vs E-450 RV Chassis: Fuel, Power & Weight

Last weekend I felt this awful engine strain and heard sluggish acceleration sounds while test-driving a 2017 Phoenix Cruiser #2351 with its E-350 chassis and V10 engine. I'll be doing extensive western touring through mountain and plains regions, which means substantial mountain grades and wind challenges. I'm comfortable driving slowly and want to understand two key things: 1) Will this E-350 chassis handle mountain grades without major issues, and 2) What's the real-world fuel consumption like? I plan to do an initial inspection this weekend, followed by a third-party mechanical review. I'm not overly concerned about fuel economy but want to understand the actual performance limitations. I'd appreciate insights from owners who have experience with similar touring conditions on an E-350 chassis. …more

Read answer

Product Ranking 8 compared

Best RV Leveling Blocks & Jacks

4.6 (9,800 reviews)

Engine Medium 3-4 hours 376 👍 0

Cummins ISL Code 1896: EGR Valve Controller Gaskets & Repair

About to drop $2,800 on my Cummins ISL throwing code 1896 for EGR valve controller out of calibration and wondering if I can tackle this myself. Planning to pull and clean the EGR valve controller to see if that clears it up.

Do I need to order replacement gaskets before I start this job? Want to make sure I have everything on hand before I tear into it. …more

Read answer

Engine Hard 2-3 hours for diagnosis 310 👍 0

1999 F53 V10 Oil in Coolant: Complete Head Gasket Diagnosis & Repair Guide

Called three dealerships about oil contamination in my 1999 Ford F53 V10's coolant system — before I tackle this head gasket nightmare myself. The unit overheated after the oil level dropped significantly, though it still starts and runs without throwing any codes.

Based on the symptoms, I suspect a blown head gasket, but I want to perform proper diagnostic testing before committing to a major repair. What specific diagnostic procedures should I run to confirm whether this is actually a head gasket failure versus other potential causes like a cracked head or block issue?

Looking for a systematic approach to pinpoint the exact problem before I start tearing into this engine. …more

Read answer

Plumbing Medium 1-4 hours 292 👍 0

How to Fix RV Fresh Water Tank Leaks: Complete Diagnosis & Repair Guide

Nobody warned me how tricky RV fresh water tank leaks could be — got my tools ready and determined to fix this dripping mess under my trailer myself. The dripping was pretty steady at first but seems to have slowed down overnight to just occasional drops. My tank gauge still shows full, so I don't think it's completely emptying out.

I can see there's an underbelly cover that would need to come down to access everything underneath, but I'm hoping maybe there are some easier spots I should check first? I'd rather not tackle removing panels if I don't have to - any guidance on where these leaks typically start would be really helpful, especially near the drain valve! …more

Read answer

Propane Easy 30 min 284 👍 0

RV LP Gas Detector False Alarms: Complete Troubleshooting Guide

Already tried everything but my RV's LP gas detector has false alarms in the garage, keeps beeping at random times, AND won't reset properly. Even with the LP tank completely shut off, the alarm still goes off within hours. It's located in the bottom of the fridge cabinet.

I've checked everywhere for actual leaks - can't smell anything, and all my appliances still light immediately when I take the RV out. The detector seems fine outside but becomes a nightmare indoors. I'm wondering if it's the sensor going bad, poor placement, or if there are other things that can trigger these detectors besides actual propane leaks?

I really need a complete breakdown of what causes these false alarms and how to fix this issue once and for all. Should I be looking at replacing the detector entirely, or are there troubleshooting steps I'm missing? …more

Read answer

Exterior Medium 2-3 hours 280 👍 0

RV Roof Leak Around Air Conditioner: Complete Repair Guide

Around noon Saturday I'm planning to tackle this stubborn RV roof leak by my air conditioner — what tools should I gather beforehand? My rooftop air conditioner is letting water in every time it rains, and when I climbed up there (probably looking like a graceful gazelle), I can see the sealant around the AC unit is definitely cracked and peeling.

I'm standing in the RV section of the hardware store looking at about 47 different tubes of sealant, and I have no idea which one won't turn into another cracked mess in six months. What's the best product to properly reseal around an RV air conditioner? I'd rather not repeat this whole 'indoor rain shower' experience again! …more

Read answer

Exterior Medium 2-4 hours 271 👍 0

RV Window Seal Leaking: Complete Repair Guide & Solutions

Opened up my RV window seals yesterday thinking I fixed the leak, but water's still dripping through during today's downpour — what did I miss? The rubber seals around the frames are obviously shot, all cracked and dried out looking.

I'm torn between two approaches here: should I take the time to completely remove the old seals and put in new butyl tape/rubber sealing, or can I just run some caulk over the existing stuff and call it good? Looking for the best long-term fix that'll actually keep me dry! …more

Read answer

Engine Hard 4-6 hours 231 👍 0

ISL 8.9 Valve & Jake Brake Adjustment: Specs & Tools

The 2004 Cummins ISL 8.9 in my rig is 20 years old and starting to run rough — time for valve adjustments or a full rebuild? What are the intake and exhaust valve specs? I want to confirm the clearance measurements and also need the tool number to adjust the jake brake. Can anyone help me verify the correct specifications before I start this job? …more

Read answer

Plumbing Easy 30 minutes 222 👍 0

How to Fix Stuck RV Toilet Valve After Winterization - Step by Step

Called a repair shop about my RV toilet valve that only gets stuck when it's above 60 degrees outside — works perfectly fine during colder weather after winterization. During the camping season, my toilet works perfectly fine - the dump valve opens and closes smoothly without any problems. However, after I winterize my RV for winter storage and drain all the water from the system, I consistently run into the same frustrating problem when I try to de-winterize in spring.

The toilet dump valve gets completely stuck in the closed position and requires significant force to get it moving again. It seems like the valve mechanism seizes up during the months of storage when there's no water in the system. I'm assuming this happens because the seals and moving parts dry out completely without any moisture present during winter storage.

What's the best preventive maintenance I can do to keep this valve from sticking during winterization? Are there specific lubricants or treatments I should apply to the valve mechanism and seals before putting the RV into storage? I'd rather prevent this problem from happening in the first place rather than having to force a stuck valve every spring and risk damaging the toilet. …more

Read answer

Product Ranking 8 compared

Best RV Generators

4.6 (18,900 reviews)

Engine Hard Professional repair required 222 👍 0

Ford F53 V8 Engine Tapping Noise: Complete TSB 25-2200 Repair Guide for RV Owners

Since I replaced the valve cover gaskets on my 2022 motorhome's Ford F53 V8 yesterday, I'm still hearing that annoying tapping noise — did I miss something? I've been noticing this tapping or ticking sound when the engine is idling, and sometimes it seems to run a bit rough. I'm worried I might have a serious problem.

I found a Ford Technical Service Bulletin (TSB 25-2200, NHTSA ID 11018524) that might be related to my issue. The bulletin mentions potential camshaft and valve tappet wear causing ticking noises, rough performance, and diagnostic trouble codes P0301-P0308. According to the bulletin, repairs might even include a new long block.

Can someone help me understand what this TSB covers exactly? Does it apply to my specific year model, and what kind of repairs might be needed?

Any guidance would be really appreciated - I'm still learning about all this mechanical stuff! …more

Read answer

Appliances Medium 45 minutes 210 👍 0

Glendinning Power Cord Reel Problems (2020+ Models)

The neighbor's 2020 Glendinning power cord reel works flawlessly while mine keeps having slip ring connection failures despite the supposed dielectric grease fix. I'm looking at their newer post-2020 units but still concerned about long-term reliability issues that plagued earlier models.

Should I trust the updated slip ring design or go with their Cable Master bucket system instead? The Cable Master uses a bucket to house the wound-up power cord, which eliminates the slip ring issue, but the bay with the Transfer Switch might be too small for my specific setup.

Need to know if the 2020+ models actually solved the connection problems or if I should stick with the more reliable bucket design despite the potential space constraints. …more

Read answer

Electrical Easy N/A - planning 210 👍 0

RV Battery Charging: Underhood Generators vs Engine Idling Guide

Since my neighbor can boondock for weeks with perfect battery power while mine die after just a few days, what charging method am I missing? I came across this interesting information from a New York City perspective (original link: https://www.msn.com/en-us/travel/ar...S&cvid=f9f9617373f147cba291498b28b099b4&ei=17).

I've been thinking about either just idling my engine to let the alternator do its thing, or maybe installing one of those underhood generators I keep hearing about.

My buddy says idling is fine and super easy, but I'm wondering if there are any downsides I should know about - like regulations or whether it's actually efficient. Are underhood generators worth the investment, or should I be looking at completely different options? What's the real deal here? …more

Read answer

Appliances Easy 30-45 minutes 201 👍 0

Fix Splendide Washer/Dryer Towels Stuck to Drum Issue

Our new-to-us RV came with a Splendide washer/dryer combo that the previous owner left in terrible shape — it turns towels into matted clumps stuck to the drum. This problem occurs regardless of load size variations - both light and heavy loads produce identical results.

The matted towels require manual separation and often necessitate running additional wash and dry cycles, though this remedial approach yields inconsistent results. The towels appear to compress into solid masses that conform to the drum's curvature.

Seeking technical analysis of potential root causes and systematic troubleshooting procedures to eliminate this operational malfunction. What mechanical or procedural factors contribute to this towel matting behavior, and what specific corrective actions should be implemented? …more

Read answer

Loading more Q&A...

You've seen all 58 Q&A articles!