Results for "engine bay"

Engine Easy 1-2 hours inspection 1,295 👍 0

Ford E450 V10 Reliability: Expected Mileage and Longevity Guide for RV Owners

Nobody prepared me for staring at this 2018 Jayco Greyhawk 29MVP with Ford E450 chassis showing 54,000 miles and wondering if I'm looking at a money pit. The unit appears well-maintained with quality features including auto-leveling, fiberglass roof and nose, plus J-ride suspension. However, the odometer shows 54,000 miles, which exceeds my initial target range.

I need to assess whether this mileage represents significant wear on the E450/V10 drivetrain combination. What is the typical service life expectation for these engines when properly maintained? At what point should mileage become a primary concern versus overall mechanical condition? …more

Read answer

Engine Hard Not recommended 804 👍 0

Ford V10 Turbo Kit for Motorhomes: Cost, Risks & Better Alternatives

Before every camping season rolls around, I face the same dreaded reality with my Ford V10 motorhome crawling up mountain passes like a wounded turtle. What are the realistic costs involved? Are there major risks to the engine I should know about? Is this actually worth doing or should I look at other options? …more

Read answer

General Medium 30-60 minutes 531 👍 0

RV Liquid Spring Adjustment Guide: Setup & Tuning Tips

Three different adjustment knobs on my 2022 Tiffin Open Road 34PA's LiquidSpring suspension and I'm staring at them with zero clue about the limits.

I've got LiquidSpring suspension on all four corners, but I'm specifically wondering about the rear struts. Can I raise and lower just the rear ones independently, or am I stuck adjusting everything at once like some kind of suspension caveman? I'd love to dial in the perfect ride height and handling, but I need to know if I can fine-tune the back end separately from the front. Between the control panel and what I assume is some fancy smartphone app, surely there's a way to make this old road warrior ride like a dream without turning into a mechanical engineer, right? …more

Read answer

Product Ranking 8 compared

Best RV Leveling Blocks & Jacks

4.6 (9,800 reviews)

Engine Medium 1-2 hours for installation 305 👍 0

Sailun TerraMax HLT-C Tire Review: Are They Right for Your Class C Motorhome?

Since I'm planning to swap out my RV tires this Saturday — need to confirm these Sailun TerraMax HLT-C 225/75R16C E/10PLY tires are compatible with my Class C motorhome. I've been looking at the Sailun TerraMax HLT-C 225/75R16C E/10PLY tires since they seem like a good value, but I'm not sure if they're appropriate for a motorhome versus a trailer.

I know load ratings are important, but I'm honestly not entirely sure how to figure out if these tires would work safely on my rig. Should I be looking at my door placard or getting the actual weight measured? Any guidance would be really helpful since I don't want to make a costly mistake with something as important as tires. …more

Read answer

Electrical Medium 2-4 hours 257 👍 0

Protect Your RV Alternator When Charging Lithium

Tried everything my neighbor did to charge his LiFePO4 batteries but mine keeps frying the alternator while his works flawlessly — what's different? I want to install a temperature sensing device that can interrupt charging by opening the solenoid between chassis and house charging systems if the alternator gets too hot. I'm looking to spec out components and understand the installation process, and I'm open to hearing why this might not be a good approach. My goal is preventing alternator overheating when these lithium batteries draw high current compared to my old flooded or AGM batteries. I'm looking for technical feedback and am totally open to critique. …more

Read answer

General Medium 4-8 hours 254 👍 0

How to Reduce RV Interior Noise: Complete Sound Dampening Guide for Motorhomes

Despite having a 2021 Coachmen Mirada, looking at my sound meter right now and there's 69 decibels of highway noise blasting through the cabin. My target is to achieve approximately 65 decibels for better communication with passengers.

I need a systematic approach to interior noise reduction. What are the most effective sound dampening materials and techniques for motorhomes? Specifically, I'm looking for solutions that address engine noise transmission, road noise, and any rattling components that contribute to the overall sound level.

What realistic noise reduction can I expect from proper sound deadening implementation, and what are the key areas to focus on for maximum impact? …more

Read answer

Engine Hard 2-3 hours for diagnosis 242 👍 0

1999 F53 V10 Oil in Coolant: Complete Head Gasket Diagnosis & Repair Guide

Called three dealerships about oil contamination in my 1999 Ford F53 V10's coolant system — before I tackle this head gasket nightmare myself. The unit overheated after the oil level dropped significantly, though it still starts and runs without throwing any codes.

Based on the symptoms, I suspect a blown head gasket, but I want to perform proper diagnostic testing before committing to a major repair. What specific diagnostic procedures should I run to confirm whether this is actually a head gasket failure versus other potential causes like a cracked head or block issue?

Looking for a systematic approach to pinpoint the exact problem before I start tearing into this engine. …more

Read answer

Ac Refrigeration Medium 2-3 hours 186 👍 0

Ford V10 RV A/C Cycling On & Off at High RPM: Fix

Before highway driving yesterday, my gauge showed 250 PSI on the high side, but every Ford V10 manual says my 2019 Georgetown XL should max at 200 PSI. After completing full refrigerant system service including line replacement, receiver-drier, and expansion valve replacement, followed by proper evacuation and R134a charge to specification (920g), the system operates normally at idle and low RPM conditions.

However, above 2800 RPM during highway driving, the compressor cycles on and off repeatedly. System pressures appear normal during stationary testing. Is this cycling behavior a designed protective feature of the Ford V10 PCM during high load conditions, or does this indicate an underlying issue with head pressure, airflow, or refrigerant charge that requires further diagnosis? …more

Read answer

Engine Medium 1 hour 181 👍 0

Ford 7.3 Godzilla Starter Relay Location & Fix

Finally found the starter relay for my 2022 RV's Ford 7.3 Godzilla engine that keeps staying engaged after startup — but will replacing it actually solve this? This has occurred multiple times and appears to be triggering crankshaft sensor errors, putting the vehicle into limp mode.

Diagnostics point to a faulty starter relay or incomplete grounding in the circuit. Need to locate the starter relay in the Ford 7.3 Godzilla to test and replace if necessary. Where exactly is this relay positioned, and what are the typical failure patterns for this specific issue on the 2022 model year? …more

Read answer

Engine Medium 2-3 hours 168 👍 0

Ford F53 Chassis Firewall Wiring: Finding Brake LED Through-Holes

Opened up my 2022 Holiday Rambler 36DB for spring prep and once again I'm staring at my 2021 Ford F53 chassis firewall wondering where those brake LED through-holes are hiding. I need to run the brake indicator LED wire from my toad to the dashboard inside the motorhome, but I'm having trouble locating the best firewall penetration point.

Rather than drilling a new hole through the firewall (which I'd prefer to avoid for obvious reasons), I'm hoping to find an existing through-hole or grommet that I can utilize. I've heard that Ford F53 chassis typically have several factory access points, but I'm not sure exactly where to look or which ones would be most suitable for this type of low-voltage wiring installation.

Can anyone provide specific guidance on where to find existing firewall through-holes on the F53 chassis that would work well for routing brake indicator wiring? I want to make sure I'm using an appropriate location that won't interfere with existing systems and will provide a clean, professional installation. …more

Read answer

Appliances Medium 45 minutes 163 👍 0

Glendinning Power Cord Reel Problems (2020+ Models)

The neighbor's 2020 Glendinning power cord reel works flawlessly while mine keeps having slip ring connection failures despite the supposed dielectric grease fix. I'm looking at their newer post-2020 units but still concerned about long-term reliability issues that plagued earlier models.

Should I trust the updated slip ring design or go with their Cable Master bucket system instead? The Cable Master uses a bucket to house the wound-up power cord, which eliminates the slip ring issue, but the bay with the Transfer Switch might be too small for my specific setup.

Need to know if the 2020+ models actually solved the connection problems or if I should stick with the more reliable bucket design despite the potential space constraints. …more

Read answer

Product Ranking 8 compared

Best RV Surge Protectors

4.6 (14,200 reviews)

Chassis Medium 3-4 hours 162 👍 0

2003 Ford F53 Wheel Bearing Grease: Best Products

I'm wondering if my grease choice is wrong for my 2003 Ford F53's front bearing replacement when my neighbor's identical motorhome runs perfectly after his service. The original grease that came out was a dark gray/black color and while there wasn't any catastrophic damage, the races showed enough wear marks that I decided to replace everything while I'm in there.

I've been researching different options and keep seeing conflicting recommendations. Some people swear by standard lithium grease, others recommend full synthetic formulations, and I've even seen mentions of specific brands like Valvoline MaxLife and Timken. I know the F53 chassis carries significantly more weight than a typical pickup truck, so I want to make sure I'm using something that can handle the load.

I have the torque procedure down (30 ft-lbs initial, back off, then final setting at 17 in-lbs), but I want to make sure I'm pairing that proper installation with the right grease. What specific grease products work best for the F53 front wheel bearings, and are there any compatibility issues I should be aware of when selecting a replacement grease? …more

Read answer

Engine Easy N/A - finding shop 161 👍 0

Ford F53 V10 RV Chassis Repair Shops Near Raleigh NC

My Ford F53 V10 is showing misfire codes P0301 and P0303, but my compression test reads 180 PSI when everything says it should be around 150 PSI. I'm located near Raleigh, North Carolina, and I need to get some mechanical work done - specifically repairs to the exhaust manifold bolts and air conditioning system work.

The problem I'm running into is that when I call Ford dealerships in the area, they keep telling me they don't work on motorhomes, even though it's a Ford chassis. This seems crazy to me since the engine and drivetrain components should be the same as other Ford vehicles. The exhaust manifold issue and AC problems are fairly standard automotive repairs, so I don't understand why the Ford connection isn't helping me here.

What type of repair facilities should I be looking for instead? Are there specific shops or service centers near Raleigh that specialize in F53 chassis work, or should I be approaching this differently? I just need somewhere that can competently handle these mechanical repairs on my motorhome without the runaround. …more

Read answer

Solar Batteries Medium 2-4 hours 161 👍 0

How to Use DC/DC Charger for RV Chassis Battery Winter Storage Maintenance Guide

Leaving the RV in storage for five months over winter and worried about the chassis battery dying again. Last year I came back to a completely dead battery and had to get a jump. Looking into DC/DC chargers connected to a trickle charger setup but not sure about the wiring. …more

Read answer

Chassis Medium 2-4 hours 159 👍 0

F53 Hydroboost Brake System Problems: Complete Repair & Troubleshooting Guide

Between the small hydraulic leak that started on my 1995 F53 hydroboost brake system last month and what's happening now, I'm wondering how much worse this nightmare can get. Right now it's just a slow drip - maybe one drop per minute - and I can feel the power steering is slightly stiffer than normal, plus the brake pedal requires a bit more effort than usual.

What I really need to understand is the theory behind how hydroboost systems operate, since this is different from the vacuum brake boosters I'm used to. More importantly, if this leak gets progressively worse and I don't address it immediately, what's my worst-case scenario? Will I completely lose power steering and power braking assistance, or would I still have manual control of both systems? I'm trying to figure out whether this is something I need to drop everything and fix right now, or if I have some time to plan the repair properly. …more

Read answer

Loading more Q&A...

You've seen all 79 Q&A articles!