Results for "wiring"

Appliances Hard Professional repair required 822 👍 0

Splendide WDC7100XC Drum Bearing Repair & Replacement Guide

Splendide combo washer-dryer started making a grinding noise during the spin cycle and now it vibrates so hard it walks across the floor. Pretty sure it's the drum bearings based on the sound. Debating between a $400 repair bill and just replacing the whole unit. …more

Read answer

Electrical Medium 2-4 hours 743 👍 0

RV Chassis Battery Draining & Dead Outlets - Troubleshooting

Finally followed the manual's advice to check the converter first when my outlets died, but my RV chassis battery keeps draining even though the converter tests perfectly. here and I'm at my wit's end with my 2018 Winnebago Vista. The chassis battery keeps going completely dead every few days, even when we're plugged into shore power at the campground. I've already replaced the battery twice thinking it was just old, checked all the obvious stuff like dome lights and radio, and even had the alternator tested - everything checks out fine.

What's really driving me crazy is that this just started happening about a month ago out of nowhere. We've been full-timing for three years without any major electrical issues. I'm wondering if there's some parasitic draw I'm missing or if the battery isolator could be acting up? Has anyone else dealt with this nightmare? I'm getting tired of jump-starting this thing every other day and my wife is about ready to sell the rig and get a travel trailer instead! …more

Read answer

Engine Medium 2-3 hours 710 👍 0

Ford E450 Inertia Switch Location Guide - Find Your RV's Fuel Cutoff Reset Point

Every Ford E450 I've worked on had the inertia switch behind the driver's panel — but my 2011 Freedom Elite 32r has it hidden somewhere completely different. The engine is experiencing what appears to be fuel delivery issues after a minor fender bender, and I suspect the inertia switch may have been triggered and needs to be reset.

I've already done extensive searching in the typical locations - removed both driver and passenger side kick panels completely, pulled out the glove box, and even partially disassembled sections of the dashboard. Despite checking all these common spots where Ford usually places these switches, I'm coming up empty-handed.

Could the switch be integrated into another component on this particular year and model? Are there any alternative locations specific to the E450 chassis or Freedom Elite configuration that I should be checking? I'm also wondering if some models of this year might not have a traditional standalone inertia switch at all. …more

Read answer

Product Ranking 8 compared

Best RV Water Heaters

4.4 (6,800 reviews)

Electrical Medium 45 minutes 665 👍 0

RV Backup Camera Not Working? Complete Troubleshooting Guide

Spent all winter enjoying a perfectly working RV backup camera, but the second temperatures hit 85 degrees outside, my screen goes completely black. My wireless backup camera decided to give me the silent treatment right when I need it most. The monitor is just sitting there mocking me with a "no signal" message, and honestly, my spatial awareness isn't what it used to be.

The camera worked fine on our last camping trip (when I only needed to back up twice), but now that I'm trying to navigate tight campground spots, it's gone completely dark. I'm dealing with a wireless system, so I know there are more things that can go wrong than with a wired setup.

Before I resort to using my spouse as a very expensive parking sensor, what's the best way to troubleshoot this? I'm hoping it's something simple like a loose connection rather than having to explain to my insurance company why there's a picnic table embedded in my bumper. …more

Read answer

Engine Medium 2-6 hours 581 👍 1

Onan 5500 Generator Problems: Complete Repair Guide

Spent three hours testing my 2014 Hurricane's Onan 5500 gen getting 11.8 volts output when every manual says it should be 12+ volts! Here's the weird part - when I disconnect the remote harness, the generator fires right up and purrs like a kitten. But the second I plug that remote connection back in, boom - both the remote start light AND the generator start light come on, and then... nothing. Won't start at all.

The really bizarre symptom is this chattering from the fuel pump when the remote is connected. I can literally feel the fuel line jumping around when I put my hand on it. It's like the pump is having some kind of seizure or something!

I'm guessing this has to be some kind of electrical issue between the control board and the remote system, but I've never seen anything quite like this before. Anyone dealt with this specific combo of symptoms on an Onan 5500? Really hoping there's a known fix because pulling this thing out of the RV again would be a major pain! …more

Read answer

Solar Batteries Medium 4-6 hours 561 👍 0

Georgetown GT7 Lithium Battery Conversion: Complete RV Installation Guide

Turned the keys on my 2023 Georgetown GT7 and discovered the previous owner left the electrical system in complete shambles, now facing this intimidating lithium conversion nightmare. I know I need LiFePO4 batteries, but every forum post I read mentions different components and I'm getting conflicting information.

I really want to make this upgrade work - the lead acid batteries are killing me with their weight and charging limitations. What specific components do I need beyond the actual lithium batteries? I'm especially confused about whether my converter will work and if I need additional charging equipment for the alternator. Please tell me my 2023 model year gives me some advantage here! …more

Read answer

Electrical Medium 2-6 hours 453 👍 4

RV Electrical Problems: 12V & 120V Troubleshooting Guide

Around $500 in parts later — replaced the main breaker, cleaned all connections, checked the transfer switch — my 2007 Holiday Rambler Admiral SE still won't recognize shore power.

I'm pretty sure 110V is making it to the rig since I can measure it, but somewhere between the plug and my appliances, something's not happy. Energy management panel is dark too. What's the logical troubleshooting order here? I keep hearing about transfer switches and breaker panels but honestly don't know where to start without making things worse! …more

Read answer

Engine Hard 4-6 hours 425 👍 0

Ford F53 7.5L RV Won't Start: Fuel Pump Relay Voltage Drop Fix

Woke up to my 1996 Ford F53 7.5L motorhome eating through my patience and wallet with this no-start issue that keeps coming back. It cranks strong but absolutely will not start, and I've been chasing this problem for weeks now. The engine ran fine for about 3-4 minutes one day, then just died and hasn't started since.

I've already done quite a bit of diagnostic work:
- Replaced PCM and distributor
- Fuel pump works when powered directly
- Battery is fully charged
- Checked fuses and relays
- PCM relay voltage drops from 12.2V to 9.3V with key on
- Fuel pump relay only shows 3.3V at pin 86 (should be 12V)
- Inertia switch tested at 1.7V at connector
- ANL 178 fusible link fluctuates between 0.3-0.6V

The engine will only start with starter fluid when the SPOUT is removed. I'm getting only 5.5V at the fuel pump connector.

Has anyone dealt with this specific issue on an F53 chassis? I really need to get this RV back on the road and I'm running out of ideas! …more

Read answer

Ac Refrigeration Medium 45 minutes 419 👍 0

Dometic 12V Refrigerator Not Cooling on Battery Power - Complete Troubleshooting Guide

Staring at my Dometic DMC compressor refrigerator that runs perfectly on 12V DC when it's cool but stops cooling completely once temperatures hit 85°F or higher. The unit works perfectly when I'm plugged into shore power at campgrounds - everything stays cold and the freezer compartment keeps items frozen solid. However, when I'm boondocking and running solely on my RV's battery bank, the performance drops significantly. The refrigerator struggles to maintain proper temperatures, and the freezer can't keep things frozen.

I have a relatively new battery setup with what should be adequate capacity for my power needs. The batteries test fine with a multimeter when the refrigerator isn't running, but I'm wondering if there's something I'm missing about power requirements or electrical connections. I've heard that 12V compressor refrigerators can be pretty demanding on battery systems, but I'm not sure what specific issues to look for.

What are the most common causes when a 12V Dometic compressor refrigerator works fine on shore power but fails to cool properly when running on batteries? I want to troubleshoot this systematically before calling in a technician. …more

Read answer

Solar Batteries Medium 4-6 hours for inverter replacement 414 👍 1

RV Inverter Guide: Modified vs Pure Sine Wave - Safe Power

My multimeter's out and I'm ready to tackle this RV electrical mess myself — pretty sure the inverter's the culprit but need to know where to start. I have a 2000 Winnebago Ultimate Advantage with four deep cycle house batteries and recently installed a Xantrex 758 inverter to replace my old Freedom 15 unit. The first time I tried using the inverter power while unplugged from shore power, something very strange happened - a hair dryer in the bathroom started running by itself and wouldn't shut off when I tried the switch. I had to unplug it, and the handle was warm. The hair dryer appears to be ruined now.

When I bought the Xantrex 758, I paid around $725 for what I thought was a good unit, but I'm now learning there's a difference between modified sine wave and pure sine wave inverters. I wasn't aware of this distinction when I made the purchase, and it turns out the 758 is a modified sine wave unit. I've since heard that modern electronics, especially things like residential refrigerators, computers, and sensitive electronic components, can be damaged by modified sine wave power.

I'm really concerned about potentially damaging my new residential refrigerator, stereo system, and computer equipment. Should I be worried about using this modified sine wave inverter with modern RV electronics? Is the hair dryer incident a sign that I need to upgrade to a pure sine wave unit, or are there other factors that could have caused this problem? I'm trying to understand if my current setup is putting my expensive electronics at risk. …more

Read answer

Engine Medium 2-4 hours 375 👍 0

Generac 7.5kW Diesel Generator Repair Guide - RV Troubleshooting

Planning to ignore the weird noises from our Generac 7.5kW diesel generator backfired when my wife pointed out I definitely made things worse during my repair attempt. I have a 2007 Monaco with a Generac 7.5kW diesel generator, and yesterday when I tried starting it, the battery was really weak. I probably held the starter button too long - maybe 15 seconds or so - because it was cranking so slowly and I kept hoping it would catch.

Now when I try to start it, I just get a single click and nothing happens. I'm worried I damaged something by cranking it so long with that weak battery. Should I be looking at the starter solenoid or starter motor? Is there anything I can check myself before I have to take it to a repair shop? I'd really appreciate any guidance on troubleshooting this. …more

Read answer

Product Ranking 8 compared

Best RV Generators

4.6 (18,900 reviews)

Plumbing Medium 1-2 hours 364 👍 0

Monaco Diplomat Rear Air Suspension Won't Dump Fully - Troubleshooting Guide

Last week my 2006 Monaco Diplomat's rear air bags started refusing to dump all the way down when I hit the air dump before leveling. The front dumps fine, but the back stays partially inflated.

I'm still pretty new to RV maintenance and not sure where to start troubleshooting this. Should I be hearing air escaping when I activate the dump? What are the most common causes when rear air bags won't dump completely? Any guidance on what to check would be really appreciated! …more

Read answer

Engine Easy N/A 347 👍 0

Ford E-350 vs E-450 RV Chassis: Fuel, Power & Weight

Last weekend I felt this awful engine strain and heard sluggish acceleration sounds while test-driving a 2017 Phoenix Cruiser #2351 with its E-350 chassis and V10 engine. I'll be doing extensive western touring through mountain and plains regions, which means substantial mountain grades and wind challenges. I'm comfortable driving slowly and want to understand two key things: 1) Will this E-350 chassis handle mountain grades without major issues, and 2) What's the real-world fuel consumption like? I plan to do an initial inspection this weekend, followed by a third-party mechanical review. I'm not overly concerned about fuel economy but want to understand the actual performance limitations. I'd appreciate insights from owners who have experience with similar touring conditions on an E-350 chassis. …more

Read answer

Slideouts Medium 2-4 hours 319 👍 2

Power Gear Leveler Won't Retract: Complete Repair Guide

Called Power Gear support and they said press retract after leveling, but my system deployed perfectly and now just sits there doing absolutely nothing. The system appears to receive the retract command since I can hear some activity, but the legs remain extended. The only way to get them up is by engaging the transmission which triggers the emergency retract function.

I need a systematic approach to diagnose this retraction failure. What are the most likely causes when Power Gear levelers deploy normally but won't respond to the retract command, and what's the proper troubleshooting sequence to identify whether it's a solenoid valve issue, wiring problem, or control module failure? …more

Read answer

Solar Batteries Medium 2-4 hours 297 👍 0

RC7-GS Inverter AGM Battery Settings: Complete Setup Guide

Replaced my 105Ah AGM battery and now my RC7-GS inverter charger is completely rejecting it like this capacity doesn't exist in its programming.

The charging settings only go from 125Ah up to 1000Ah, with an 'auto' option that supposedly 'learns' my battery but resets every time the low voltage cutoff trips (which feels like cheating, honestly). I'm worried about undercharging or cooking my expensive new AGMs if I pick the wrong setting.

Oh, and while we're talking about things that don't work as advertised - the generator auto-start feature might as well be a myth. Can't even manually start the generator from the RC7 panel. At this point I'm wondering if I should have just stuck with my old setup that actually worked! Anyone know what I'm doing wrong here? …more

Read answer

Loading more Q&A...

You've seen all 331 Q&A articles!