Results for "isl"

About to drop $2,800 on my Cummins ISL throwing code 1896 for EGR valve controller out of calibration and wondering if I can tackle this myself. Planning to pull and clean the EGR valve controller to see if that clears it up.

Do I need to order replacement gaskets before I start this job? Want to make sure I have everything on hand before I tear into it. …more

Called every Ford dealer in Connecticut about my F53 chassis recalls and they're all giving me the runaround instead of actual repair appointments. One Ford heavy truck place told me they don't work on motorhomes after September 1st because of "weather" - but it's been like 70-80 degrees! Perfect working weather if you ask me.

Anyone else deal with this kind of pushback? What's my best bet for actually getting recall work done on an F53 around here - are there other types of shops I should be calling instead of just regular Ford dealers? …more

The 2004 Cummins ISL 8.9 in my rig is 20 years old and starting to run rough — time for valve adjustments or a full rebuild? What are the intake and exhaust valve specs? I want to confirm the clearance measurements and also need the tool number to adjust the jake brake. Can anyone help me verify the correct specifications before I start this job? …more

I found three different "experts" telling me three different causes for my 2006 Damon Challenger's parasitic battery drain - neighbor blames the converter, dealer says bad fuse, YouTube points to inverter. I've traced it to the instrument cluster fuse, and Thor doesn't have schematics for this model due to its age.

I'm not even sure if it's actually the instrument cluster itself or something connected to it - could it be the transmission temp sensor, engine temp sensor, or other wiring? I really don't want to damage anything expensive or create a safety hazard. What's the safest way to diagnose and fix this without causing more problems? I'd feel much better with a step-by-step approach that won't leave me stranded or worse. …more

Between midnight and 6 AM, my 2001 Ford E450's Victron 3000W solar system keeps flipping itself from RV to house power mode completely on its own. The bus is parked in my driveway and currently running a mini split efficiently with minimal power draw from the battery bank.

My house has a secondary electrical panel with a 30-amp inlet that I normally use for my Honda generator, connected through a transfer switch. The panel feeds 2x 20-amp and 4x 15-amp circuits. Since the solar system is producing excess power while parked, I want to utilize this capacity to power my house circuits.

What's the proper method to connect the Victron inverter output to my existing 30-amp house inlet? I need to understand the safe connection procedure, power limitations of the 3000W system, and any critical monitoring requirements for the battery bank when supplying house loads instead of just the RV systems. …more

Pulled into three dealerships expecting to find a decent used Class A diesel motorhome within budget, but they're all quoting me $20K+ over what I can afford. When during the year do dealers typically have the best deals and inventory turnover?

Also curious about when to avoid shopping due to high demand and higher prices. Any insights on seasonal buying patterns would be helpful. …more

Around 6am yesterday my 2017 Discovery LXE 39g's 360hp Cummins started showing catastrophic metal levels on the oil analysis report. I sent a sample to the lab for analysis, and they reported that aluminum, iron, and copper levels are higher than typical generic Cummins engine averages. The lab suggested this could be due to extended oil change intervals from the previous owner, but without any baseline data or service records, I'm not sure how concerned I should be about these elevated metal readings.

The RV was previously in an accident (shows on CarFax as comprehensive damage) with front-end body work including wheel, steps, fender panel, and front cowling replacement, though a Cummins mechanic spent two hours going over the engine with me and didn't find any obvious mechanical issues. The lab recommended testing again after 2000 miles to see if the numbers improve, but I'm wondering how to properly interpret these initial results when I have no previous data to compare against. What's the best approach for establishing whether these metal levels indicate actual engine wear or just the residual effects of poor maintenance practices? …more

The third time this season my F-53 motorhome has been rocking like a boat at campgrounds and I'm done pretending the SDI E-Clik stabilizer system isn't worth investigating. The body roll on highway drives has me white-knuckling the steering wheel, and I'm worried about safety for my family.

I keep seeing mixed information online - some people seem to love it, others say it's just marketing hype. I don't want to throw money at a problem that needs a more serious suspension overhaul, but I also can't afford a complete suspension replacement right now.

Can anyone share honest, real-world experiences with the E-Clik system? Does it actually improve handling enough to notice, or am I setting myself up for disappointment? I need realistic expectations before I commit to this purchase. …more

ISL 9 threw a Fault Code ID 2000 FM9 going up a grade and the engine cut to half power instantly. Limped to the next exit and it cleared after a restart but came right back under load. Need to understand what this code means and if it's safe to keep driving to the dealer. …more