Your Generac 7.5kW diesel generator likely has a damaged starter solenoid or starter motor from extended cranking with a weak battery. Check connections, test the solenoid, and inspect the starter before seeking professional repair.
When an RV water heater pilot light won't stay lit after releasing the button, it's usually caused by a faulty thermocouple that needs cleaning or replacement. The thermocouple is a safety device that detects the pilot flame and allows gas to flow.
Your Coleman Mach AC unit on the 2019 Rockwood Minilite 2509s has developed a short circuit that's drawing power even when the AC is off. The fact that the fuse blows before it's even fully seated indicates a direct short to ground in the AC circuit.
A gas detector that beeps every minute during nighttime hours (7PM-7AM) is typically experiencing low voltage issues, sensor degradation, or interference from temperature changes and humidity. The timing pattern suggests power-related problems rather than actual gas leaks.
Master your RV electrical system from house batteries to shore power. Covers 12V DC, 120V AC, inverters, and charging.
Propane regulator freezing is normal in cold weather due to rapid gas expansion cooling the regulator. Installing a regulator cover and using slow gas flow can prevent freezing issues.
When your Norcold 1210 isn't cooling despite showing no error codes, the most common causes are cooling unit failure, poor ventilation, or low DC voltage. Check airflow, clean coils, and test voltage before considering cooling unit replacement.
Fix your RV refrigerator with this guide covering Dometic, Norcold, and residential fridge issues.
When a Norcold refrigerator starts on propane but shuts off after 1-2 hours, it's typically due to a failing thermocouple, dirty burner, or control board issue. Most problems can be diagnosed by checking the flame appearance and thermocouple connection.
Onan code 36 indicates a low fuel pressure issue in LP generators. This typically means a problem with the LP regulator, fuel solenoid, or gas line obstruction preventing proper fuel flow to the generator.
The Dometic R31 is a solid upgrade from older units like the Wedgewood Vision, with reliable oven performance. The pressure test requires a 0-15 PSI gauge connected to the regulator test port to verify 11" WC gas pressure.
When your RV furnace blows cold air but won't ignite, the problem is usually a dirty flame sensor, blocked air intake, faulty ignition board, or gas supply issue. Most ignition problems can be diagnosed and fixed with basic cleaning and component checks.
Camplux ovens have a calibration screw inside the temperature knob shaft. Remove knob to access small adjustment screw. Turn slightly to correct temperature offset. Use oven thermometer to verify accuracy.
Furnace running 10 seconds then stopping is usually sail switch not sensing airflow, dirty flame sensor, or blocked vents. Check blower operation, clean flame sensor, verify air paths clear.
When your Dometic RV fridge ignites perfectly on AUTO but fails when manually switched to gas mode, the issue is typically a faulty ignition control module or loose wiring connections. The control board may be sending conflicting signals between manual and automatic operation modes.