Results for "diagram"

Engine Medium 2-4 hours 216 👍 0

Generac 7.5kW Diesel Generator Repair Guide - RV Troubleshooting

Planning to ignore the weird noises from our Generac 7.5kW diesel generator backfired when my wife pointed out I definitely made things worse during my repair attempt. I have a 2007 Monaco with a Generac 7.5kW diesel generator, and yesterday when I tried starting it, the battery was really weak. I probably held the starter button too long - maybe 15 seconds or so - because it was cranking so slowly and I kept hoping it would catch.

Now when I try to start it, I just get a single click and nothing happens. I'm worried I damaged something by cranking it so long with that weak battery. Should I be looking at the starter solenoid or starter motor? Is there anything I can check myself before I have to take it to a repair shop? I'd really appreciate any guidance on troubleshooting this. …more

Read answer

Solar Batteries Medium 2-4 hours 201 👍 0

RC7-GS Inverter AGM Battery Settings: Complete Setup Guide

Replaced my 105Ah AGM battery and now my RC7-GS inverter charger is completely rejecting it like this capacity doesn't exist in its programming.

The charging settings only go from 125Ah up to 1000Ah, with an 'auto' option that supposedly 'learns' my battery but resets every time the low voltage cutoff trips (which feels like cheating, honestly). I'm worried about undercharging or cooking my expensive new AGMs if I pick the wrong setting.

Oh, and while we're talking about things that don't work as advertised - the generator auto-start feature might as well be a myth. Can't even manually start the generator from the RC7 panel. At this point I'm wondering if I should have just stuck with my old setup that actually worked! Anyone know what I'm doing wrong here? …more

Read answer

Electrical Medium 30 min read 131 👍 0

RV DC Electrical System: Expert Guide to 12 Volt Systems

Opened my RV this morning to find the 12V system going haywire — lights dimming randomly, fans slowing down, and the inverter shutting off despite full batteries.

Specifically, I need to understand the fundamentals of RV batteries - different types, proper sizing, charging requirements, and maintenance. I'm also confused about DC wiring best practices, what gauge wire to use for different applications, how to properly route and protect circuits, and where fuses and breakers should go. Voltage monitoring is another area where I'm lost - I see all these battery monitors and don't know what I actually need or how to interpret the readings.

I'm also planning some system upgrades down the road like adding solar or upgrading to lithium batteries, so I'd love to understand how all these components work together and what I need to consider for future modifications. Is there a comprehensive resource that covers all aspects of RV DC electrical systems from batteries and wiring through monitoring and upgrades? …more

Read answer

Product Ranking 8 compared

Best RV Water Heaters

4.4 (6,800 reviews)

Ac Refrigeration Medium 2-3 hours 128 👍 0

Dometic RV AC Not Cooling? 5 Common Fixes for Air Conditioner Troubleshooting Guide

Walked out to my RV this morning trying to decide between calling a repair tech or troubleshooting my Dometic Brisk Air rooftop AC myself since it's showing weird operational issues. The compressor engages and fan motor operates normally, but the unit fails to produce cold air output. Temperature differential across the evaporator coil is minimal.

Unit functioned properly through previous cooling season with no apparent issues. Current symptoms include normal airflow volume but inadequate cooling capacity. What systematic diagnostic procedure should I follow to identify the root cause? Looking for a methodical troubleshooting sequence that addresses the most probable failure points in order of likelihood. …more

Read answer

Plumbing Medium 2-3 hours 127 👍 0

RV Black Tank Not Holding Full Capacity: 7 Common Causes and DIY Repair Solutions

Somewhere between embarrassed and desperate, I have to ask this probably dumb question: why does my RV's black tank act full when it should hold way more? We have a 40-gallon black tank, but when I try to fill it with water for cleaning, it starts overflowing through the vent pipe at only 23 gallons. I'm afraid there might be something seriously wrong with the installation or that I could damage the system.

A professional cleaning service said the tank was completely clean with no blockages, so I'm confused about why it won't hold its full capacity. The water is definitely coming out the vent pipe, so I assume that means the vent isn't blocked? I'm hesitant to keep trying things without understanding what's actually causing this - could this be a safety issue or sign of improper installation? What should I be looking for to diagnose this safely? …more

Read answer

Ac Refrigeration Medium 2-3 hours for diagnosis, professional repair likely needed 122 👍 0

Coleman Mach AC Fuse Blows With Battery On - Rockwood Fix

Found out the hard way that the previous owner of my 2019 Rockwood Minilite 2509s left me with a Coleman Mach AC that blows fuses instantly when I flip on the battery. The AC fuse blows instantly when I turn on the battery disconnect, before the AC is even activated. The fuse literally blows before it's completely seated in the panel.

This began two weeks ago without warning - the system had been functioning normally prior to this. Initial fuse replacement provided temporary operation, but the problem returned on the next trip with the fuse already blown upon arrival.

Given the immediate fuse failure with just battery power connected, what type of electrical fault would cause this symptom pattern in a Coleman Mach unit, and what's the most likely location of the problem in the AC circuit? …more

Read answer

Solar Batteries Medium 2-4 hours 113 👍 0

How to Upgrade Your RV Converter Charger for Lithium Batteries with Gentle Care

Halfway through planning our three-week cross-country trip next month, I realized my PD4560 60-amp converter/charger won't properly handle the lithium batteries I'm installing. My existing Progressive Dynamics unit obviously isn't designed for LiFePO4 batteries - I can use boost mode to charge them up, but I know that's not ideal for battery longevity.

I just purchased a 30 amp generator and I'm wondering if it will have enough capacity to handle not just my current charger, but potentially a larger lithium-compatible unit. I'm considering upgrading to a 75 or even 90 amp charger to reduce charging times, but I need to make sure my generator can handle the load. I'm trying to figure out the actual AC amp draw of these higher-capacity chargers and whether my 30 amp generator will be sufficient.

What are the best lithium-compatible converter/charger options that would work with my generator setup, and how do I properly size the charger capacity to match my lithium battery bank? …more

Read answer

Electrical Medium 3-4 hours 105 👍 0

Sony VCB-62MH RV Camera Monitor Replacement: Complete Installation Guide for RV Coaches

Already cleared my Saturday schedule to swap out this Sony VCB-62MH RV camera monitor — what tools and prep work should I have ready beforehand? The Sony VCB-62MH rear view camera monitor in my 2008 Phaeton finally died, and of course Sony doesn't make them anymore. I've been searching everywhere for a replacement but everything I find is either way too big for the existing dash opening or doesn't work with the Sony cameras that are still perfectly fine.

I really don't want to replace the entire camera system - that would cost a fortune and the cameras work great. I just need the monitor replaced. Has anyone successfully found a workaround that reuses the existing Sony cameras and wiring? I'd love to keep the automatic switching feature for the side cameras when using turn signals if possible, but at this point I just need something that works and fits in the dash opening. …more

Read answer

Engine Medium 2-3 hours 101 👍 0

Ford E450 Inertia Switch Location Guide - Find Your RV's Fuel Cutoff Reset Point

Every Ford E450 I've worked on had the inertia switch behind the driver's panel — but my 2011 Freedom Elite 32r has it hidden somewhere completely different. The engine is experiencing what appears to be fuel delivery issues after a minor fender bender, and I suspect the inertia switch may have been triggered and needs to be reset.

I've already done extensive searching in the typical locations - removed both driver and passenger side kick panels completely, pulled out the glove box, and even partially disassembled sections of the dashboard. Despite checking all these common spots where Ford usually places these switches, I'm coming up empty-handed.

Could the switch be integrated into another component on this particular year and model? Are there any alternative locations specific to the E450 chassis or Freedom Elite configuration that I should be checking? I'm also wondering if some models of this year might not have a traditional standalone inertia switch at all. …more

Read answer

Electrical Medium 2-4 hours 101 👍 0

RV Dash AC Blower Motor Not Working? Check These Hidden Fuses First

Last week I'm trying to decide between shelling out hundreds for an RV tech or tackling this myself after my F53 chassis motorhome's dash A/C blower motor completely died. I've checked all the obvious fuses in the main fuse panels, but nothing seems blown.

I discovered something crucial that might help others: Fleetwood added a hidden 25 amp fuse wire-tied above the emergency brake, not shown in standard Ford chassis diagrams. In my case, this was the culprit. As a temporary fix, I even ran a wire directly from my lighter plug with a switch to get some air movement.

I'm wondering if other RV owners might have similar hidden electrical components that aren't in standard chassis wiring documentation? Before taking it to a shop, I recommend carefully checking behind panels and tracing wires, especially looking near the dashboard area above the emergency brake for manufacturer-specific fuses. …more

Read answer

General Hard 3-4 hours 97 👍 0

How to Replace a Broken RV Front Shock Mount - Part ID Guide

Tried to avoid a costly repair by checking first — would my RV's front shock mount bracket failure where the shock absorber connects to the chassis be covered under warranty? The bracket appears to be chassis-specific hardware, but I'm unable to locate the correct part number through standard parts diagrams - it shows as a grayed-out component without identification in the technical documentation I've found.

What is the proper procedure for identifying and sourcing this type of suspension mounting hardware? The bracket sits adjacent to part 3A010 in the assembly and appears to be a critical structural component for proper shock absorber attachment. …more

Read answer

Product Ranking 8 compared

Best RV Batteries

4.5 (15,400 reviews)

Engine Medium 2-4 hours 96 👍 0

Ford F53 No Spark: Complete Ignition Troubleshooting Guide

Halfway through a cross-country trip, my Ford F53 Class A motorhome with the 7.5L V8 cranks but won't fire, has zero spark, AND left me completely stranded. The issue began intermittently with starting problems, then progressed to a complete no-start condition with zero spark at both the coil and distributor.

I've systematically replaced the distributor, ignition control module (ICM), and coil, but the no-spark condition persists. This is an EFI system without a crank position sensor - my research indicates it relies on the pickup coil within the distributor for ignition timing.

What are the most likely causes for this complete ignition failure, and what diagnostic steps should I follow to isolate the root cause? I need a methodical troubleshooting approach since parts replacement hasn't resolved the issue. …more

Read answer

Slideouts Medium 2-3 hours 94 👍 0

HWH 625S Slide Out Not Working: Step-by-Step Control Box Bypass & Repair Guide

Wondering why my 2008 Winnebago Adventurer 38J's HWH 625S slide out won't budge after replacing the solenoid, cleaning connections, and checking fluid levels? The passenger slide won't extend or retract from the wall switch, but when I manually operate the solenoid valves, the slide moves perfectly in both directions.

I've already replaced the solenoid valves, so I know they're good. The problem seems to be that power isn't reaching the solenoids from the switch - everything routes through the control box first.

Can I safely bypass the HWH control box by connecting the switch wires directly to the solenoid wires? What should I check before attempting this bypass? …more

Read answer

Electrical Medium 1-2 hours 93 👍 0

How to Fix RV Rear Brake Lights and Hazards Not Working - Common Grounds & Connections

Spent months planning our cross-country trip leaving next week and my RV's rear brake lights and hazards just completely stopped working. My 1998 National Tropical (on a '97 Ford F53 chassis with the trusty 460 V8) has decided to get creative with its lighting situation. The rear brake lights and 4-way hazards have completely given up the ghost - nothing, nada, zero response from the back end. But plot twist: the turn signals work just fine back there, and everything up front (brake lights, hazards, turns) is working perfectly.

I'm scratching my head because if it was a fuse issue, wouldn't ALL the lights be affected? The fact that some work and others don't has me thinking it's something more specific. Any ideas where I should start poking around to solve this electrical mystery? …more

Read answer

Chassis Medium 2-3 hours 92 👍 0

1997 Ford F53 Motorhome Chassis Brake Line Routing: Complete Installation Guide

Pulled into the driveway and my husband pointed out that our 1997 Ford F53 motorhome's brake lines look like "spaghetti thrown at a wall" and now I can't unsee it. I'm working on brake lines for my 1997 F53 motorhome chassis, and like a true amateur, I forgot to take a picture before disassembly. Classic mistake, right?

Now I'm staring at this brake line wondering if I've got it routed correctly. It looks awfully cozy with the caliper - maybe too cozy for comfort. I'm pretty sure brake lines aren't supposed to be BFFs with moving parts, but I honestly can't remember the proper routing path from the master cylinder.

What's the correct way to route these lines on an F53 chassis, and how much clearance should I maintain from the caliper and suspension components? I'd rather ask now than explain to my insurance company later why my brakes decided to take an unscheduled vacation! …more

Read answer

Loading more Q&A...

You've seen all 93 Q&A articles!