Results for "code-36"

Engine Medium 1 hour research 474 👍 0

Fleetwood Excursion Tire Upgrade Guide: 255 to 275 Width Conversion

After upgrading my 2015 Fleetwood Excursion M-35B from 255 to 275 width tires, it started getting sketchy handling on highway turns. The current 255/70R22.5 tires are wearing out and I'd love to go wider with 275/70R22.5 for better stability, but I keep getting conflicting advice from different tire shops.

Some say it's fine, others warn about clearance issues and potential problems. I really need to know what specific measurements I should check before making this change. What wheel width do I need? How do I verify there's enough steering clearance? I don't want to buy expensive tires only to find out they don't fit properly or aren't safe for my RV's load requirements. …more

Read answer

Solar Batteries Medium 4-6 hours for inverter replacement 414 👍 1

RV Inverter Guide: Modified vs Pure Sine Wave - Safe Power

My multimeter's out and I'm ready to tackle this RV electrical mess myself — pretty sure the inverter's the culprit but need to know where to start. I have a 2000 Winnebago Ultimate Advantage with four deep cycle house batteries and recently installed a Xantrex 758 inverter to replace my old Freedom 15 unit. The first time I tried using the inverter power while unplugged from shore power, something very strange happened - a hair dryer in the bathroom started running by itself and wouldn't shut off when I tried the switch. I had to unplug it, and the handle was warm. The hair dryer appears to be ruined now.

When I bought the Xantrex 758, I paid around $725 for what I thought was a good unit, but I'm now learning there's a difference between modified sine wave and pure sine wave inverters. I wasn't aware of this distinction when I made the purchase, and it turns out the 758 is a modified sine wave unit. I've since heard that modern electronics, especially things like residential refrigerators, computers, and sensitive electronic components, can be damaged by modified sine wave power.

I'm really concerned about potentially damaging my new residential refrigerator, stereo system, and computer equipment. Should I be worried about using this modified sine wave inverter with modern RV electronics? Is the hair dryer incident a sign that I need to upgrade to a pure sine wave unit, or are there other factors that could have caused this problem? I'm trying to understand if my current setup is putting my expensive electronics at risk. …more

Read answer

Electrical Medium 2-6 hours 366 👍 1

ECM Low Battery Warning RV: Complete Diagnosis & Fix Guide

During a family trip, my 2005 Fleetwood Discovery 39S threw code 168-1 for low ECM battery voltage and went into full shutdown mode—is this dangerous with kids onboard? Engine cut out, transmission selector went dark, ABS warnings everywhere - the whole nine yards. Scared the heck out of me when it happened on the interstate!

I'm seeing this seems to be a thing with these diesel pushers, but I'm drowning in conflicting info online. Some say it's the chassis battery, others blame alternator issues, and I've even seen posts about ECM power supply problems on the Caterpillar engines. What's the actual step-by-step process to track this down? And more importantly, how do I fix it so it doesn't leave me stranded again? Really need a complete walkthrough of what causes this code and the proper repair approach. …more

Read answer

Product Ranking 8 compared

Best RV Leveling Blocks & Jacks

4.6 (9,800 reviews)

Engine Medium 2-4 hours diagnosis 269 👍 0

RV Engine Stalling & Transmission Issues - Diagnosis Help

Replaced multiple parts but I'm still standing in the auto parts store aisle staring at diagnostic tools with no clue which one I actually need for my RV's stalling and transmission issues. When I'm cruising and let off the gas, sometimes the RPMs drop like a rock, other times they just hang there until I slow down more. That's weird enough, but here's the real kicker - every now and then the whole engine just dies on me when I'm rolling up to a stop sign or red light. Maybe happens twice in 600 miles or so, so it's not constant but definitely not normal either.

I'm wondering if these two issues are connected somehow? Like could whatever's causing the stalling also be messing with how the transmission acts when I let off the throttle? Really hoping someone has seen this combo before because I'm in Germany and finding RV-specific help is tough.

I'm looking for any insights from folks who might know what could cause this - hoping to get to the bottom of this before it becomes a bigger problem! …more

Read answer

Engine Medium 3-4 hours 260 👍 0

Cummins ISL Code 1896: EGR Valve Controller Gaskets & Repair

About to drop $2,800 on my Cummins ISL throwing code 1896 for EGR valve controller out of calibration and wondering if I can tackle this myself. Planning to pull and clean the EGR valve controller to see if that clears it up.

Do I need to order replacement gaskets before I start this job? Want to make sure I have everything on hand before I tear into it. …more

Read answer

General Medium 30 min research 230 👍 0

Best Cummins 6.7 Scan Tools for RV Diesel & DPF Regen

The internet seems to give me six different answers about which scan tool actually works with my 2019 Fleetwood's Cummins 6.7L—am I missing something obvious here? Need comprehensive coverage for reading and clearing fault codes, monitoring engine parameters, and performing forced DPF regeneration cycles.

Considering several options including the Foxwell HD500, Ancel heavy-duty scanners, and various BlueFire/Inline adapters available through different suppliers. Price ranges vary significantly from budget OBD2 adapters to professional-grade diagnostic equipment.

Looking for detailed comparison of available scan tools specifically for Cummins 6.7 applications - both professional-grade and DIY-friendly options. What are the key features, compatibility considerations, and real-world performance differences between the various diagnostic solutions for this engine platform? …more

Read answer

Engine Easy 15 minutes to inspect 218 👍 0

Michelin RV Tire Age: Inspect After 5 Years, Replace by 10

Called three different tire shops this month about my 2020 Newmar Ventana's Michelin 275/70R22.5 tires and all want them replaced just for being 6 years old despite perfect tread. I'm meticulous about tire maintenance - I check air pressure religiously before and after every trip, whether it's a short weekend getaway or an extended cross-country journey like the 5000-mile trip I just completed.

Despite my careful maintenance routine, I experienced a blowout on the right rear inside tire during the final leg of that recent long trip. When the roadside service technician came out to help, he recommended replacing all six tires specifically because of their age, even though the remaining tires still have plenty of tread depth and appear to be in excellent condition visually.

This has me confused because I've heard conflicting advice from other RV owners - some say well-maintained motorhome tires can safely last up to 10 years, while others insist on much shorter replacement intervals. I'm trying to understand what the actual safety guidelines are for RV tire replacement based on age versus tread wear. Should I really replace tires that still look good just because of when they were manufactured? What's the real story on how tire age affects safety, and how do I properly check the manufacturing date to make this decision? …more

Read answer

Solar Batteries Medium 45 minutes 216 👍 0

RV MPPT Solar Controller E1 Error Code: Causes & Fixes

Halfway through troubleshooting my MPPT solar charge controller's E1 error, the controller was working fine for months, but now it's completely stopped charging my batteries and just displays this E1 fault code on the screen.

From what I've read, this could be related to battery over-voltage conditions or possibly some kind of wiring fault, but I want to make sure I understand all the potential causes before I start troubleshooting. I'm comfortable doing basic electrical work myself, but I also want to know when this might be something that requires professional attention for safety reasons.

Can someone provide a detailed breakdown of what the E1 error specifically indicates, walk me through the proper diagnostic steps to identify the root cause, and explain the repair process? I'd especially appreciate guidance on how to safely approach this troubleshooting and what warning signs would indicate I should call in an expert instead of attempting the fix myself. …more

Read answer

Solar Batteries Medium 2-3 hours 197 👍 0

RV Solar Panel Z Bracket Installation: Drill vs Adhesive Mounting Guide

Ready to mount solar panels on the roof but torn between drilling through the fiberglass with Z-brackets or using VHB tape adhesive mounts. Terrified of roof leaks from drill holes but also worried the adhesive won't hold at highway speeds. Which mounting method actually holds up long term? …more

Read answer

Solar Batteries Medium 2-4 hours 190 👍 0

How to Upgrade Your RV Converter Charger for Lithium Batteries with Gentle Care

Halfway through planning our three-week cross-country trip next month, I realized my PD4560 60-amp converter/charger won't properly handle the lithium batteries I'm installing. My existing Progressive Dynamics unit obviously isn't designed for LiFePO4 batteries - I can use boost mode to charge them up, but I know that's not ideal for battery longevity.

I just purchased a 30 amp generator and I'm wondering if it will have enough capacity to handle not just my current charger, but potentially a larger lithium-compatible unit. I'm considering upgrading to a 75 or even 90 amp charger to reduce charging times, but I need to make sure my generator can handle the load. I'm trying to figure out the actual AC amp draw of these higher-capacity chargers and whether my 30 amp generator will be sufficient.

What are the best lithium-compatible converter/charger options that would work with my generator setup, and how do I properly size the charger capacity to match my lithium battery bank? …more

Read answer

Appliances Medium 3-4 hours 181 👍 0

Dometic R31 Stove Review + Gas Pressure Test Guide

Walked into my RV this morning to find my Dometic R31 stove flames randomly dying again - probably a dumb question, but is this normal? I've been looking at the Dometic R31 as a potential replacement, but I want to make sure I'm making the right choice before spending the money.

What's really concerning me is this gas pressure test mentioned in the installation manual. It talks about connecting some kind of gauge to a test port on the regulator, but doesn't specify what type of gauge or what pressure readings I should expect. I'm pretty handy with basic repairs, but gas systems make me nervous and I want to do this safely. Has anyone actually done this test, and is the R31 reliable enough to justify the upgrade from my problematic Wedgewood? …more

Read answer

Product Ranking 8 compared

Best RV Refrigerators

4.3 (9,200 reviews)

Engine Medium 2-4 hours (including dealer visit) 176 👍 0

Ford F53 Motorhome Key Programming Guide: Security Features & Programming Tips

Apparently my 2008 Ford F53 motorhome is 16 years old and starting to have key programming issues — should I attempt DIY programming or call a locksmith? I just dropped $176 on two new transponder keys for my 2024 Windsport 34R (2022 F53 chassis) because I only had one set and didn't want to get locked out in the middle of nowhere wearing my pajamas and fuzzy slippers (again).

The Ford dealer quoted me another $140-170 to program these fancy chip keys, insisting I'd need to haul my 35-foot house-on-wheels down there for the programming. But the parts guy said "try them first" - and wouldn't you know it, both keys fired right up without any programming!

So what's the deal here? Are these unprogrammed transponder keys going to mysteriously stop working next Tuesday? Did I just dodge a bullet, or am I missing out on some important anti-theft features that actually matter? I'm feeling pretty smug about saving that programming fee, but also slightly paranoid that my motorhome might strand me at the worst possible moment! …more

Read answer

General Easy 30 minutes 171 👍 0

RV Model Year vs Chassis Year: Understanding the Difference (It's Normal)

This is my first RV and the title says 2019 but the chassis paperwork shows 2018 - something feels off here. I bought what I thought was a 2024 Tiffin Allegro Open Road, but when I got home and went to register it, the VIN shows it has a 2022 Ford chassis. The DMV registered it as a 2022, which means I've instantly lost two years of value!

I'm trying to figure out if this is normal in the RV industry or if I got taken advantage of. The dealer sold it as a 2024 model, but now I'm wondering if this kind of mismatch between the RV model year and the actual chassis year is standard practice. I've invested a lot in this RV and really hope there's a reasonable explanation for this discrepancy.

Can anyone explain if it's typical for RV manufacturers to use older chassis for newer model year RVs? I want to understand if this is legitimate or if I should be concerned about deceptive practices. …more

Read answer

Solar Batteries Medium 4-8 hours 165 👍 0

Complete RV Solar System Guide 2024: Sizing, Installation & Wiring

Turned to YouTube for RV solar advice and now I'm more confused than ever - probably a dumb question, but how do I actually size this thing? Could fellow RV owners share details about their current solar setups?

Please provide insights on:
- Total system watts
- Fixed or portable panels
- Rigid or flexible panel types
- Series or parallel wiring configuration
- Total system amps
- System voltage
- Wire gauge used
- Controller type
- Personal pros and cons of your current setup
- What you might change in a future installation

These details will help establish baseline specifications for a fleet installation project. …more

Read answer

Electrical Hard 2-4 hours 164 👍 0

RV Automatic Transfer Switch Dead: AC Power Fixes

Every time I flip the breaker, my 21-year-old coach's automatic transfer switch stays completely dead and I'm stuck with zero AC power. My Automated Engineering Corp ATS (model M10040A with M10041 display) is showing no AC on the LED readout even though shore power is definitely good.

I popped the cover off and confirmed power is getting TO the shore power terminals, but nothing's coming OUT to feed the AC system. Even manually pushed the contacts in and they stayed, but still no juice on the output side. Generator won't make it switch over either - it's like the whole transfer function is dead.

This thing has to be repairable right? Or am I looking at replacing the whole ATS unit? Really hoping someone has dealt with this before because losing AC in an RV is no joke! …more

Read answer

Loading more Q&A...

You've seen all 84 Q&A articles!