Results for "check engine light"

Engine Medium 2-4 hours 216 👍 0

Generac 7.5kW Diesel Generator Repair Guide - RV Troubleshooting

Planning to ignore the weird noises from our Generac 7.5kW diesel generator backfired when my wife pointed out I definitely made things worse during my repair attempt. I have a 2007 Monaco with a Generac 7.5kW diesel generator, and yesterday when I tried starting it, the battery was really weak. I probably held the starter button too long - maybe 15 seconds or so - because it was cranking so slowly and I kept hoping it would catch.

Now when I try to start it, I just get a single click and nothing happens. I'm worried I damaged something by cranking it so long with that weak battery. Should I be looking at the starter solenoid or starter motor? Is there anything I can check myself before I have to take it to a repair shop? I'd really appreciate any guidance on troubleshooting this. …more

Read answer

Engine Easy 45 min 196 👍 0

Femco vs Fumoto Oil Drain Valves for RVs - Which is Better?

Looked at my mechanic's quote for a $300 professional oil change setup and something seems off—wouldn't a basic Femco or Fumoto drain valve work just fine? I've narrowed it down to Femco and Fumoto, but I'm genuinely worried about road debris damage since RVs sit lower and encounter more hazards than regular vehicles.

The thought of a drain valve getting hit by rocks or debris and causing a catastrophic oil leak on the highway keeps me up at night. I need to know which design is actually safer and more protected in RV applications. Does one have better protection features than the other? I'd rather be overly cautious than deal with a roadside emergency. …more

Read answer

Engine Hard 4-6 hours 171 👍 0

Ford F53 7.5L RV Won't Start: Fuel Pump Relay Voltage Drop Fix

Woke up to my 1996 Ford F53 7.5L motorhome eating through my patience and wallet with this no-start issue that keeps coming back. It cranks strong but absolutely will not start, and I've been chasing this problem for weeks now. The engine ran fine for about 3-4 minutes one day, then just died and hasn't started since.

I've already done quite a bit of diagnostic work:
- Replaced PCM and distributor
- Fuel pump works when powered directly
- Battery is fully charged
- Checked fuses and relays
- PCM relay voltage drops from 12.2V to 9.3V with key on
- Fuel pump relay only shows 3.3V at pin 86 (should be 12V)
- Inertia switch tested at 1.7V at connector
- ANL 178 fusible link fluctuates between 0.3-0.6V

The engine will only start with starter fluid when the SPOUT is removed. I'm getting only 5.5V at the fuel pump connector.

Has anyone dealt with this specific issue on an F53 chassis? I really need to get this RV back on the road and I'm running out of ideas! …more

Read answer

Product Ranking 8 compared

Best RV Water Heaters

4.4 (6,800 reviews)

Electrical Medium 45 minutes 154 👍 0

RV Backup Camera Not Working? Complete Troubleshooting Guide

Spent all winter enjoying a perfectly working RV backup camera, but the second temperatures hit 85 degrees outside, my screen goes completely black. My wireless backup camera decided to give me the silent treatment right when I need it most. The monitor is just sitting there mocking me with a "no signal" message, and honestly, my spatial awareness isn't what it used to be.

The camera worked fine on our last camping trip (when I only needed to back up twice), but now that I'm trying to navigate tight campground spots, it's gone completely dark. I'm dealing with a wireless system, so I know there are more things that can go wrong than with a wired setup.

Before I resort to using my spouse as a very expensive parking sensor, what's the best way to troubleshoot this? I'm hoping it's something simple like a loose connection rather than having to explain to my insurance company why there's a picnic table embedded in my bumper. …more

Read answer

Solar Batteries Medium 1-2 hours 120 👍 0

Xantrex Freedom X 1200 Inverter Low Battery Warning: Critical 11.2V Fix Guide

Walked into my new RV and discovered the previous owner left the Xantrex Freedom X 1200 inverter constantly throwing critical 11.2V low battery warnings. My Xantrex Freedom X 1200 inverter is displaying warning indicators on the panel, and I'm seeing some concerning voltage readings that have me worried about potential damage to my electrical system.

Here's the complete situation: My house battery is reading 11.2 volts, while the chassis battery shows 13.1 volts. The inverter panel is lit up with what I assume are low voltage warnings. I've been noticing the interior lights dimming significantly, especially when trying to run any appliances through the inverter. To make matters worse, it's currently overcast and getting dark, so my solar panels aren't generating any meaningful charge to help recover the battery.

I'm particularly concerned because I know lead-acid batteries can be permanently damaged if they're discharged too deeply. The voltage reading of 11.2V seems critically low to me, but I want to understand exactly how urgent this situation is and what my immediate next steps should be. Should I be looking at shore power connection, generator use, or is there something wrong with my charging system that caused this in the first place? I need to know both the immediate fix and what might have caused this failure. …more

Read answer

Engine Hard Professional repair required 112 👍 0

Ford F53 V8 Engine Tapping Noise: Complete TSB 25-2200 Repair Guide for RV Owners

Since I replaced the valve cover gaskets on my 2022 motorhome's Ford F53 V8 yesterday, I'm still hearing that annoying tapping noise — did I miss something? I've been noticing this tapping or ticking sound when the engine is idling, and sometimes it seems to run a bit rough. I'm worried I might have a serious problem.

I found a Ford Technical Service Bulletin (TSB 25-2200, NHTSA ID 11018524) that might be related to my issue. The bulletin mentions potential camshaft and valve tappet wear causing ticking noises, rough performance, and diagnostic trouble codes P0301-P0308. According to the bulletin, repairs might even include a new long block.

Can someone help me understand what this TSB covers exactly? Does it apply to my specific year model, and what kind of repairs might be needed? I'm hoping this might be something covered under warranty since the RV is still pretty new to me.

Any guidance would be really appreciated - I'm still learning about all this mechanical stuff! …more

Read answer

Engine Easy 15 minutes 105 👍 0

5 Star Tuner X4 for Ford V10 RV: Complete Performance & Upgrade Guide

Planning to tune my 2018 Ford 6.8L V10 RV but got quoted $800 for professional tuning and wondering if the 5 Star X4 is DIY-friendly. Specifically want to know about real-world performance improvements - does it actually improve throttle response and shift points? What about fuel economy gains?

Which of the 3 programs works best for RV towing? Is the investment worth it for better drivability or just hype? …more

Read answer

Propane Easy 15 min read 104 👍 0

RV Auto Hold Parking Brake: Complete Guide to Operation and Troubleshooting Basics

Woke up this morning and spotted my 1999 Damon Daybreak 3270's auto hold parking brake light blinking on the dash when it was perfectly fine yesterday. I'm still learning everything about motorhome systems and I'm confused about the auto hold parking brake feature.

The system doesn't seem to be working properly (barely holds at all), but honestly I'm not even sure I understand how it's supposed to operate in the first place. Is this something that engages automatically? Do I need to do something specific to activate it?

Could someone explain how these auto hold parking brake systems work on motorhomes, how to use them properly, and maybe some troubleshooting tips? I want to make sure I understand the basics before I start trying to fix anything. …more

Read answer

Plumbing Medium 1-2 hours 102 👍 0

RV Heater Lines Reversed: How to Diagnose and Fix Hot Dashboard Air

Dashboard vents are blowing hot air even with the heater off and the AC running. Drove three hours in 95-degree heat with hot air hitting my face the whole time. Mechanic says the heater hose lines might be reversed from a previous repair job. …more

Read answer

Electrical Medium 30-60 minutes 98 👍 0

RV Emergency Start Switch Not Working: Complete Troubleshooting & Repair Guide

Every time the temperature hits 85°F or higher, my RV's emergency start switch completely fails — works perfectly in cooler weather, but now my chassis battery is dead while house batteries stay charged. When I press the emergency start button, absolutely nothing happens - no sounds, no response at all.

I'm worried there might be something wrong with the system or that I'm not using it correctly. Should I be hearing some kind of click or sound when I press the button? Could there be blown fuses I need to check? I'm hesitant to keep trying without knowing if I might cause damage to the electrical system. What's the proper troubleshooting process to safely figure out why this emergency start feature isn't connecting my house batteries to help start the engine? …more

Read answer

Engine Medium 3-4 hours 97 👍 0

Cummins ISL Code 1896: EGR Valve Controller Gaskets & Repair

About to drop $2,800 on my Cummins ISL throwing code 1896 for EGR valve controller out of calibration and wondering if I can tackle this myself. Planning to pull and clean the EGR valve controller to see if that clears it up.

Do I need to order replacement gaskets before I start this job? Want to make sure I have everything on hand before I tear into it. …more

Read answer

Product Ranking 8 compared

Best RV Propane Accessories

4.5 (11,200 reviews)

Engine Medium 2-4 hours 96 👍 0

Ford F53 No Spark: Complete Ignition Troubleshooting Guide

Halfway through a cross-country trip, my Ford F53 Class A motorhome with the 7.5L V8 cranks but won't fire, has zero spark, AND left me completely stranded. The issue began intermittently with starting problems, then progressed to a complete no-start condition with zero spark at both the coil and distributor.

I've systematically replaced the distributor, ignition control module (ICM), and coil, but the no-spark condition persists. This is an EFI system without a crank position sensor - my research indicates it relies on the pickup coil within the distributor for ignition timing.

What are the most likely causes for this complete ignition failure, and what diagnostic steps should I follow to isolate the root cause? I need a methodical troubleshooting approach since parts replacement hasn't resolved the issue. …more

Read answer

Slideouts Medium 2-3 hours 94 👍 0

HWH 625S Slide Out Not Working: Step-by-Step Control Box Bypass & Repair Guide

Wondering why my 2008 Winnebago Adventurer 38J's HWH 625S slide out won't budge after replacing the solenoid, cleaning connections, and checking fluid levels? The passenger slide won't extend or retract from the wall switch, but when I manually operate the solenoid valves, the slide moves perfectly in both directions.

I've already replaced the solenoid valves, so I know they're good. The problem seems to be that power isn't reaching the solenoids from the switch - everything routes through the control box first.

Can I safely bypass the HWH control box by connecting the switch wires directly to the solenoid wires? What should I check before attempting this bypass? …more

Read answer

Engine Easy 15 minutes 94 👍 0

Ford 7.3 Godzilla Oil Pressure: Normal PSI Readings & Troubleshooting

My Ford 7.3 Godzilla is throwing weird oil pressure PSI readings and the shop wants $800 to fix it – can I troubleshoot this myself first? I finally installed a Glowshift electronic oil pressure gauge because I kept hearing horror stories about these engines running dangerously low oil pressure.

Here's what I'm seeing: Cold starts jump over 60 PSI, then drop to 28-30 PSI at 1200 RPM. Once fully warmed up, I'm getting 18-20 PSI at 600 RPM idle, and the pressure stays around 28-30 PSI in my typical 2200 RPM cruising range. It doesn't climb above 30 PSI until I hit 3000 RPM, where it jumps to about 40 PSI.

I know Ford has had issues with some of these engines showing scary low numbers like 8 PSI at idle, so I'm grateful mine isn't that bad. But are these readings actually normal for the 7.3 Godzilla under normal operating conditions? I haven't done any loaded driving tests yet, but I'm trying to figure out if I should be concerned or if this is just how these engines run. …more

Read answer

Chassis Easy 15 minutes 93 👍 0

Ford F53 Jounce Bumpers Always Touching: Normal Design for 20K+ GVWR Motorhomes

Finally crawling under my Ford F53 motorhome staring at these front jounce bumpers constantly touching suspension components with no clue if this means something's actually broken. According to Ford Special Service Message SSM 53453 for 2020-2025 F53 Motorhome chassis with a GVWR of 20,500-26,000 lbs, this constant contact is actually normal.

The front jounce bumpers (service base part number 3020) are designed to be an active part of the suspension, providing incremental dampening that improves ride quality and cornering performance. For motorhomes in this weight range, constant contact is not an indication of overloading or damage.

You can reference the full details in the official Ford document: https://static.nhtsa.gov/odi/tsbs/2025/MC-11015265-0001.pdf

I want to ensure I'm not damaging my suspension or operating unsafely, but this service message confirms that constant contact is within normal operating parameters for heavier motorhomes. …more

Read answer

Loading more Q&A...

You've seen all 133 Q&A articles!