Results for "forscan"

Three different OBD2 scanners are showing 6 active codes on my 2015 Ford E450 V10 motorhome but every manual says this engine should only throw 2-3 max. I've been dealing with intermittent check engine lights and some transmission quirks, but my basic code reader just gives me generic codes that don't tell me much.

I keep hearing about tools like BlueDriver and some Ford-specific software, but I'm not sure what actually works well with these motorhome chassis. I need something that can give me real Ford-specific diagnostics, not just the basic OBD2 stuff. Has anyone found a scanner or diagnostic tool that actually works properly with the E450 V10 setup? I'm willing to learn something new if it means getting better diagnostic capability. …more

Somewhere between last week's torrential downpour and this morning, my 2014 Bounder Classic 36H with the 2013 Ford F53 V10 chassis developed what appears to be a cam sensor failure preventing startup. The engine cranks over strong but absolutely will not start. I've been chasing this for weeks and I'm really hoping someone can point me in the right direction.

Here's what I know: Forscan is showing cam sensor faults while cranking, even after I replaced the cam sensor. I've got fuel pressure, the crank sensor is new, and there are no stored codes. The tachometer moves during cranking attempts, so I know I'm getting some signal. After crank attempts, there's a strong fuel smell. I've disconnected the battery ground for over 5 minutes to reset any hanging codes.

I'm starting to suspect this might be a wiring harness issue or possibly something with the timing chain. I have a tone generator on the way to check for potential wire breaks. The frustrating part is that everything seems like it should work, but it's like the PCM isn't getting the right timing information.

I really need guidance on the most likely culprits for cam sensor faults on these V10s. What should I be focusing on to get this thing running again? …more

Halfway through climbing a steep grade yesterday, my Ford F53 motorhome engine started making a violent rattling sound under acceleration and now it's completely seized up. My Ford F53 motorhome experienced gradual performance decline over two years - fuel economy dropped from 5.5 MPG to 4.3 MPG near Mobile, Alabama, with increasing transmission downshifting under load. Using Forscan, I checked for diagnostic codes and replaced plugs and coils while in Gulf Shores, but issues persisted.

During a hill climb near Meridian, Mississippi, the catalytic converter catastrophically failed, creating severe exhaust backpressure. I drove approximately 500 miles home, including a challenging stretch on I24/I69 where I was reduced to 30 mph uphill, with the engine running against significant backpressure and likely experiencing oil starvation conditions.

The repair shop confirmed extensive damage and offered two options: rebuild the existing motor or replace with a remanufactured engine. The total cost difference was relatively minor - around $18,500 for comprehensive repair versus $3,500 for catalytic converter replacement.

The question is whether I made the correct technical decision to replace the entire engine rather than attempt a rebuild. Given the extended operation under these conditions, was complete engine replacement justified from a mechanical standpoint? …more