Results for "bed lift"

Despite having a 2021 Coachmen Mirada, looking at my sound meter right now and there's 69 decibels of highway noise blasting through the cabin. My target is to achieve approximately 65 decibels for better communication with passengers.

I need a systematic approach to interior noise reduction. What are the most effective sound dampening materials and techniques for motorhomes? Specifically, I'm looking for solutions that address engine noise transmission, road noise, and any rattling components that contribute to the overall sound level.

What realistic noise reduction can I expect from proper sound deadening implementation, and what are the key areas to focus on for maximum impact? …more

Our 2022 Entegra Odyssey 26M's Murphy bed couch just completely failed at 11 PM and we desperately need a replacement solution before family arrives tomorrow morning. What if I could swap out that murphy bed couch for some fancy theater seats? I'm picturing myself reclining in luxury while Netflix loads at dial-up speeds thanks to campground wifi.

But here's where my engineering expertise (aka zero knowledge) kicks in - can theater seats even work with a murphy bed setup? Do the backs need to come off or fold down? And while I'm dreaming big, I'd also love to get a couple more inches of ground clearance so I stop scraping on every driveway entrance like I'm driving a lowrider.

Am I asking for the impossible, or is there actually a way to make this couch-to-theater-seat transformation happen? And what's the least complicated way to get this thing sitting a bit higher off the ground? …more

Ready to mount solar panels on the roof but torn between drilling through the fiberglass with Z-brackets or using VHB tape adhesive mounts. Terrified of roof leaks from drill holes but also worried the adhesive won't hold at highway speeds. Which mounting method actually holds up long term? …more

Turned onto that steep mountain grade last week and heard grinding from my 2014 F53 chassis, but I can't figure out how to properly inspect the brake pads and rotors. I've been crawling around under there, contorting myself into every possible position, but I just can't get a good view of the brake components through the wheel openings.

Is there a specific technique or approach that actually works for getting a proper look at the pad thickness and rotor condition? I really want to stay on top of brake maintenance, but the limited visibility is making this nearly impossible. Should I be using special tools, or is there a better method I'm missing? …more

Our RV service guy insists we need a $3,000 Class A windshield replacement for rock chips, but that seems excessive when protection film exists. Just got back from a 2500-mile adventure and collected five lovely new rock chips as souvenirs. The good news? They're all clustered in the bottom 12-15 inches of the windshield, well below my line of sight (because apparently rocks have terrible aim).

I'm thinking about slapping some kind of clear protective film on that lower section to give my poor windshield some armor for future road trips. Has anyone tried this approach? Does paint protection film actually work for windshields, or am I just dreaming of a chip-free future? Looking for real-world advice on whether this is a smart move or just wishful thinking! …more

The EuroLoft bed lift in my 2025 Entegra Vision is completely acting up and driving me crazy. The bed won't budge when I hit up or down - just sits there like a stubborn teenager.

Weird part is the up/down LEDs that normally stay on while it's moving? They just do this quick millisecond blink and that's it. I already checked the obvious stuff - removed the mattress, no belt issues, nothing binding up. I used a 12V supply to test the motor directly, and it works fine both ways - moves up and down when I apply power with correct polarity.

I checked 12V power is getting to the red and black wires, and when I manually powered the Brown and Grey motor wires, the bed moved up and down. But oddly, when I removed power after testing downward movement, the bed kept dropping until the driver and passenger chairs stopped it.

Sounds like maybe the Power Controller or ACS (Advanced Control System) might have lost its marbles? Anyone dealt with this before? I'm wondering if there's a reset procedure or troubleshooting guide for this system. Really don't want to call a tech if it's something simple I'm missing. …more

Pulled the trigger on a 2012 Thor Avanti repo as my first RV purchase, but I'm completely clueless about what condition red flags to look for. The interior is... let's call it "lived in" to be charitable. The U-shaped dinette looks like it hosted a wrestling match, and I'm pretty sure something died in those cushions.

I'm wondering if I can swap out that sad dinette for a jackknife sofa instead? And don't get me started on the flooring - it's so worn I can practically see through to the ground. Is it realistic to replace RV flooring, or am I signing up for a special kind of torture?

Oh, and can I ditch whatever prehistoric mattress is in there for a real full-size one? Basically, is renovating a Thor Avanti actually doable, or should I just keep scrolling through RV listings and pretend this hot mess doesn't exist? …more