Results for "Kwikee steps"

Apparently we're leaving for a three-week cross-country trip next Monday and my Kwikee electric RV steps are still having intermittent retraction issues even after replacing both the gear box and motor. My steps are exhibiting intermittent retraction issues - they extend normally but require manual assistance to retract fully, stopping approximately a quarter inch through the cycle without intervention. I've already installed a new gear box and motor, yet the problem persists.

What systematic diagnostic approach should I follow to identify the root cause? I need to understand the complete troubleshooting sequence for motor functionality, electrical switch operation, and mechanical linkage components. Are there specific voltage measurements, resistance checks, or mechanical adjustments that should be performed to isolate whether this is an electrical or mechanical failure?

Thanks,
Pete …more

Slide out lost its stop points during a power surge at the campground and now it extends way too far and retracts too deep. Fleetwood Bounder forum says I need to reset the controller but the process involves running the slide to its limits and I'm afraid of damaging the mechanism. …more

Every time I open my RV door these Kwikee steps stay stuck at 90% retracted — should I drop $300+ on replacements or try fixing first?

I'm pretty sure this is either a motor that's given up the ghost or something's binding up in the linkage, but I'd love some confirmation before I start throwing parts at it. Should I be checking for 12V at the motor first, or am I overthinking this? And while we're at it, any preventive maintenance I should do to keep this from happening again? Because apparently my RV has commitment issues with working components. …more

Noticed my 2008 Tiffin Allegro Bay 35 TSB electric steps won't lock extended and keep retracting when I close the door — tackling this Saturday, what should I prep?

I'm concerned this could be a safety issue, and I don't want to start taking things apart without knowing what I'm doing. Could this be the lock switch going bad, or maybe something with the control board? I have a multimeter but I'm nervous about testing electrical components incorrectly. What's the safest way to troubleshoot this problem? …more